n95 chinese supported or no?

[Pandemonio100]

Sorry for question but this chinese n95 is supported by Infinity box i can only read information whit V3 usb cable but can't read full flash to try to update language.

Action: read information
Model: Autodetect 6205-6227 NOR
Checking data, wait...
Phone should be Switched ON !
Connecting, wait...
Phone detected, wait...
Hardware version: MT6226, E02
Software version: B10_EFATRIS_V0929A"
Software date: 2005.04.12
Barcode: 102101MT012345678901234567 10
imei: 3578350100xxxxx
Finished, time used: 4 sec
Power off phone now !


i receive always this error when try to read full flash.

COM6 [USBSER000] selected
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection active
Action: read NOR flash
Boot...
Press and HOLD Power button now !
baud autodetection active
9600
Connecting, wait...
error: boot phase#1 failed
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect" box.
Boot Fail
Finished, time used: 3 sec
Remove/Install battery now !

[InfinityHelp]

hello!

you must build special cable for flashing operations.

[Pandemonio100]

ok i had thought that cable is not good but this phone have connector as V3 so i can build one cable and try to read flash but scheme?;)

[InfinitySupport]

You have not so many pins to try as Rx/Tx.
Just find Gnd and +V, try rest pins as Rx/Tx.

[hagard]

use this pinout mate..

http://i4.tinypic.com/86yd1d4.jpg

[Pandemonio100]

Ok very good i try to read in this way however i need translate after read flash in italian right or exist language to change directly?

[/ARIF/]

n95 100% supported by infinity.....................

[Pandemonio100]

use this pinout mate..

http://i4.tinypic.com/86yd1d4.jpg

Sorry but this is a COM cable not USB right?

[InfinityHelp]

hello Pandemonio100!

yes, this is com port cable.
from box rj45 to phone

[Pandemonio100]

Ok sorry for all this question but i need understand now i have this box what's pinout for built cable?;)
Tanks