Hi. I need flash for ZTC N38

[IkaMazini]

Hi. I need flash for ZTC N38

COM6 [VCP0] selected
Device: Autodetect 6228 NAND
Checking data, wait...
Action: read/check detailed information
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
Initializing[6228:8A02:8A02]...
chip: 0031:0000:0101
boot step size: 0400
Release Power button now !
Boot Done
Initialize...
version: 3.1
loader: 3.1.02
NAND: Hynix HY27XS08121M 512+16 32 pages, 66Mb
NAND id: AD76AD76
page size: 200+10
pages/block: 20
bits i/o: 08
address cycles: 04
blocks: 1000
ram size: 00800000
NOR: 0000:000000000000 [00000000]
NAND: 00AD:007600AD0076 [04200000]
NOR chip is not installed
Initialize Done
Set baud...
921600
Set baud Done
Identification...
reading structure area...
detecting structure...
source data: page+spare
converting data...
done 0x00010000 bytes
identification#1 protocol ver: 04
ver. sw1: U6_PCB04_GPRS_MT6228_S02.U6V10B20.BIN
ver. sw2: U6V10B20
ffs offset/size: 01700000/02900000
id-page Ok
nfi area detection finished: Ok
identification#1 structure: 2nd [standard] generation
Finished, time used: 25 sec
Remove/Install battery now !

[InfinityHelp]

hello!

what problem with phone? did you try already safe and then complete format of your phone?
maybe this will fix your problem.

[IkaMazini]

mr infinityhelp after 15 minute mobile turning off. :( hardware damaged?

[IkaMazini]

and please see this post (http://gsmhosting.com/vbb/showthread.php?t=487110)

[InfinityHelp]

hello!

hard to say if it is hardware fault or software.
you can make full backup for emergency case and try to format ffs (safe & complete)

what is in that post? infinity and saras box pinouts. what about them?