Motorola L6 Dead! Plz Help

[lahoot]

FLASHING COMPLETE BUT NOT POWERD UP
HERE'S LOG

Clip serial: 945186877, version: 4.01, initializing... OK
Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version...
io timeout
Searching for phone... found S Blank Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 2.00
Reading flash id... ST - M30L0R8000B0
Phone group: A630,E1,E37x,E39x,E55x,L6,U6,V3,V190,V330,V53x,V54 x,V55x,V62x,V635,V80
Hardware IMEI: 352512018549939
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE 352512018549939.mbk"
Login request... OK
Writing flash section 4 of 4... 100% (11.3 Kb/sec)
Restarting phone... OK
Searching for phone... found S Blank Neptune LTE
Switching to flash mode... OK
IMEI OTP status: locked
Repair PDS request... OK
Performing PDS repair... OK
Writing flash section 1 of 1... 100% (18.6 Kb/sec)
Please write a corresponding Full_flash file to phone to complete repair
Writing flash section 2 of 2... 100% (59.6 Kb/sec)
Flash completed!

[rihan3080]

motorola c350 no service

[janinuk]

i am having the same problem. it says flash complete but screen doestn't come up. when detect by smartmoto search it says.... "found S Blank Neptune LTE, getting test interface.... interface not found"
did you get any solution or just hopeless like me.
gimme a reply plz

[janinuk]

hi: is there any body who can solve this puzzle.?????????????????????????????

[Ayush]

I'm also in the same boat. This L6 won't start. With some flash file the keypad backlight would remain on for 20 seconds, but with some only for 5sec. There ain't any display at all. No proper backup of phone was taken and there ain't any original boot loaders available, so upon writing the downloaded boot loaders from internet, there ain't any display other thank blank screen in Boot Loader mode. I also replaced the Flash with a blank one, but still nothing. Here is the log from Smart Clip.

SmartMoto 3.17
S-Card: xxxxxxxxx Smart-Clip dongle, v 2.10, assigned Smart-Clip: xxxxxxxxxxxx Europe, initializing... OK
Clip serial: xxxxxxxxx, version: 4.08, initializing... OK
Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 8.D0
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Flash Neptune LTE
Switching to flash mode... OK
Reading phone boot version...
io timeout

Searching for phone... found S Blank Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 2.00
Reading flash id... ST - M30L0R8000B0
Phone group: A630,E1,E37x,E39x,E55x,L6,U6,V3,V190,V330,V53x,V54 x,V55x,V62x,V635,V80
Hardware IMEI: xxxxxxxxxxxxxxxxx
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE xxxxxxxxxxxxxxx.mbk"
Login request... OK
Writing flash section 4 of 4... 100% (11.5 Kb/sec)
Restarting phone... OK
Searching for phone... found S Blank Neptune LTE
Switching to flash mode... OK
IMEI OTP status: locked
Repair PDS request... OK
Performing PDS repair... OK
Writing flash section 1 of 1... 100% (19.6 Kb/sec)
Please write a corresponding Full_flash file to phone to complete repair
Writing flash section 2 of 2... 100% (60.3 Kb/sec)
Flash completed!
Applying IMEI patch, please wait (up to 2 minutes!)... OK
IMEI patch successfull, set new IMEI with the "Write" button
Writing new IMEI xxxxxxxxxxxxxxx... OK
Turning phone off... OK


As it can be seen from the log, I did the following :
1. PDS Repair
2. Write Full Flash including boot area
3. Repari IMEI

This usually works for almost all the phones. Strange it ain't working for this one. I've all reasons to belive this maybe a hardware problem, but can't square on the fault.

Any ideas?