possible flash via usb cable

[green bird]

hi supporter and all readers; chinies phones flash (i don't have cable) possible via usb cable.
for ex. i have n82 dual sim but i don't have cable. i have usb cable i try to flash but get error.

COM11 ready
Action: read information
Model: Autodetect 6205-6227 NOR
Checking data, wait...
Phone should be Switched ON !
Connecting, wait...
Phone detected, wait...
Hardware version: MT6226, E02
Hardware version: MALATA26_05C_HW
Software version: MAUI.05C.W06.16"
Software date: 2005.04.12
Barcode: MT012345678901234567
imei: 135790246811220
Finished, time used: 4 sec
Power off phone now !

COM11 [USBSER001] selected
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
eeprom backup enabled, it may takes several minutes !
Action: write NOR flash
"smart write" active
write: Firmware
skip: Customization
skip: Language Pack
skip: Eeprom/ffs
Boot...
Press and HOLD Power button now !
baud autodetection active
9600
Connecting, wait...
error: boot phase#1 failed
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect" box.
Boot Fail
Finished, time used: 4 sec
Remove/Install battery now !

[InfinitySupport]

Hello,

you must use Rx/Tx/Gnd cable but not USB cable.