View Full Version : plz i want pin out
my dyar
plz help me for pin out
141006
InfinityHelp
02-12-2008, 22:44
hello!
may we know at least phone mode, connector type, GND pin location?
thanke you my dear
this another pic
141034
141035
InfinityHelp
02-13-2008, 14:43
hello!
still cant get phone name, connector type, gnd pin location.
can you tell us in words?
hi friend its one off this ???? else go to C:/prog files/infinity/pinout and do surch(n95).....you will fins more picture with ther pinouts:D:D
thanke you traxgsm
but all this pic i have
and all this pinout is not work
?????????
this n95 china black rm159
please tell us
1- connector type((12pins or 5 pins....))
2-the gnd pin location ((gnd in pin 1 or in pin 2 .....))
hope we can help you after you give us this informations
connector type = 5 pins
gnd = pin2
InfinityHelp
02-13-2008, 23:32
hello!
most 5pin n95 uses test points on PCB.
try pin 3/4 as datalines in both variants:
3 as tx, 4 as rx
3 as rx, 4 as tx.
if will not work make good resolution photo of PCB so we could see test points and advice you them
sabasaba
03-02-2008, 13:48
please, i need pinout for the phone
sabasaba
03-02-2008, 13:52
12 pin from n95 slider not work
InfinityHelp
03-02-2008, 17:40
hello!
GND pin is on correct place?
change places (swap) tx and rx wires and try to connect again
sabasaba
03-03-2008, 11:52
not work. INFINITYHelp pleasehelp mi
sabasaba
03-03-2008, 11:56
not work. INFINITYHelp please help mi. gnd is ok. and Tx Rx not found
InfinityHelp
03-03-2008, 12:49
hello!
it must work
12 pin conector:
6,7- data lines
1,5- GND
sabasaba
03-04-2008, 06:50
thank, but not work.
InfinityHelp
03-04-2008, 11:36
hello!
must work, try to change tx/rx wires with places
check if GND pins in your connector is on same place as in given pinout