View Full Version : i-mobile 516 new firmware detected !!
hi infinity , i saw this message when i try to read detailed information
BUT where to press repair security area :rolleyes: ?? i cant find this tab ....
New firmware detected:
ARIMA26_06A_PCB01_GPRS_MT6226_S01.7S7110MY00-001-R1A.BIN
- make "Repair security area" operation
- send "backup_system_log_..." file to support !
- make "Read full flash" operation
- send flash backup file(s) to support
ver. sw1: ARIMA26_06A_PCB01_GPRS_MT6226_S01.7S7110MY00-001-R1A.BIN
ver. sw2: 7S7110MY00-001-R1A, 9D13D2D3
InfinitySupport
03-04-2008, 09:03
Hello,
Sorry, my fault, button is missing, will be fixed in next update.
Anyway, "backup_system_log" was created during "read flash" procedure so everything is not so bad.
Files received, will be prepared and uploaded in support area.
Hello,
Sorry, my fault, button is missing, will be fixed in next update.
Anyway, "backup_system_log" was created during "read flash" procedure so everything is not so bad.
Files received, will be prepared and uploaded in support area.
all right , 1 more question , i receip a china 6300 with double encryption , mean cant not read from a good phone & flash to another phone , it Including security on cpu id , can u fix this problem ?? i aready read out the firmware & send to support , hope can fix asap ... TQ :D
InfinitySupport
03-04-2008, 13:28
Hello,
Yes, possible. "backup_system_log" file should be attached together with flash backup.
What was 6300 firmware version name ?
backup_system_log including with the rar file i send on 3/2/2008 2:33 PM
firmware name & version is : LEDA26_06A_PCB01_GPRS_MT6226_S01.MAUI_06A_W06_48_2 6
unluckyman
03-25-2008, 18:31
hi infy!
I need pinout I-mobile 516, pinout 2_GND, 5_TX, 9_RX in support not work
InfinitySupport
03-25-2008, 19:06
hi ulkmn !
just swap Rx and Tw wires
unluckyman
03-25-2008, 19:16
thanks infy reply. not ok
InfinitySupport
03-25-2008, 20:07
hi eklmn !
check cable again. your cable is bad, software works for sure so you must check cable again.
unluckyman
03-26-2008, 10:33
thanks infy
i fromat by infy:
COM3 [VCP0] selected
Action: reset settings
Model: I-Mobile 516
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
19200 autodetect
Initializing[6226:8A02:8A01]...
CPU: MT6226
chip: 0031:166D:27C5
Connecting, wait...
error: can't finalize test mode
repeat operation and HOLD phone "Power" button long time !
error: operation failed !
Finished, time used: 96 sec
Remove/Install battery now !
InfinitySupport
03-26-2008, 10:47
hi eprst !
make "complete" format