View Full Version : ZTC TV88 pinouts??????
Unlocker AL
03-14-2008, 16:08
can anyone give me a scheme how to make cable for this phone?
GND RX TX?
thx
InfinityHelp
03-14-2008, 17:56
hello!
first of all open phone and make sure that it is based on MT62xx MCU.
also look arround for marked test points on PCB.
if there is no any test points, and MCU is supported-
post here connector type, we will try to help
Unlocker AL
04-11-2008, 10:32
i think this kind of Phone does not support from Infinity box.also Multibox.
i can t see in any list of supported phones
thx
today i tried their on the pcb rx and tx is mentioned clearly...but phone unable to attach with infinity...
this cell was ok suddenly became dead,this is dual sim with tv cell model is ZTC TV88...
image is attached
HERE IS THE CPU AND FLASH IC DETAIL
cpu ic no1 MT6225A
0743-AGSL
ITGW0385[/B]
flash ic no1 spansion
71pl127nbohfw4u
750xvm83 L
KOREA
06 SPANSION
cpu ic no2 MT6205BA
0726-ENSL
AJ7F9
flash ic no2 spansion
71GLO16A-40BFWIG
742VVK41 E
CHINA
05 SPANION.
ONE MORE IC IS THEIR ON PCB I DODNT KNOW FOR WHAT IT IS HERE IS THE DETAIL
MT6318A
0721-DYSL
MP109
INFI TEAM KINDLY DO THE BNEED FULL.
REGARDS!
zoro2001
06-19-2008, 18:40
it work fine with infinity and pinfinder
i test 1 phone and all ok
cable used is L10C
rx 7
tx1
regards
zoro2001
MasterUnlocker
thanks zoro ur cable info was right...since afternoon i Was trying cable L10B....NOW its ABLE TO DETECT THE RX AND TX WITH L10C..
kindly tell me how i use this pinfinder to detect second cpu which is MT6205AB. THE FIRST CPU WAS MT6225 WHICH I FORMAT EASILY
REGARDS!
InfinitySupport
07-14-2008, 15:58
Hello,
Go to "More..." PinFiner menu, disable pinout that you already found and try to detect pinout again.
in more optin ...pinfinder menu.... i disable 7RX and 1TX then also pin finder failed to detect pins.
kindly assit ..............or should i open th phone and directly solder the rx and tx for second cpu.
regards!...............
InfinitySupport
07-14-2008, 16:47
It may be that you need to open phone, find POWER_B test point, connect POWER_B to Gnd and repeat 2nd CPU detection process.
i gaveup its not happening...i format only single cpu and when switch ON the cell bothh.the sim works simultaneously.
REGARDS!
motosamy
08-22-2008, 13:12
need
RX AND TX tv88
With fee
InfinityHelp
08-22-2008, 23:15
helllo mr. motosamy!
this pinout is not ok: ?
http://www.gsmhosting.com/vbb/showpost.php?p=3410327&postcount=6
motosamy
08-31-2008, 20:50
Thank you zoro and infinty