View Full Version : BE1 "batt. charge impossible!"
farsands
07-31-2002, 14:20
Hello! How to fix this problem or where can I get service manual, anyone?
wrong section moved from Alcatel BE1-BE5
mr_x4you
07-31-2002, 20:56
Try clean battery contacts !
farsands
07-31-2002, 23:54
Hi! Thanks for your reply.
Have cleaned all contacts and even replaced external charging interface. Sometimes, even with newly charged battery, the unit does not power on but after a while I try it again and then it powers on. Once on, the unit works fine, but it still does not charge. I think I have to look further than batt. contacts...what next?
GSMlearner
08-01-2002, 00:55
change ic PTWL2207
george gsm
08-01-2002, 07:10
hi,
take in this order:
1. clean the contacts conector & board . clean contacts of batery(see mr_x4you answer)
2. repair soft. if u have not soft 4 this send a mail to geogsm@yahoo.com and i will reply
3. change power ic (see GSMleaner's answer)
geo
Hi!
I think Your problem is software cose It happend many times to me! Contact me on icq: 149039664! I will help U!
My best regards to all!
cosmo
mr_x4you
08-01-2002, 14:55
Try to unlock it again with Andromeda, sometime works ! If not try repair with Mihnea flashes !
Replace your battery..., if not, change big Capacitor..
these are the problems for Batter Charge Not possible problem
1) Software
2) Power IC
3) Chinese made battery...(use original battery)
.... rest is yet 2 be found...
regards
ukaryagar
06-13-2003, 00:06
hello from TURKEY...
CHARGE PROBLEM FOR BE1 AND BE3...
ONLY WAY .....YOU CHANGE IC PTWL 2207....
TAKE CARE...
www.interfon.8m.com
what if if the fone is indicating that it s charging by itself i.e without being connected to the charger could power ic replacemnt solve this?
farsands
06-16-2003, 15:46
Hello!
Thanks for your replies....You happen to have schematics/service manual? That would help a great deal!
Sandy
farsands
06-16-2003, 15:56
Hello Robba!
In principle, charging indicator showing charging but without charger means the charging control IC or switch is defective...there is a short...if only I can get a schematics/diagram for that to help locate the part (or the adjoining resistors/gnd connect/capacitor to replace), then I can fix it.
Sandy
@ farsands
this should help in schematics (http://http://www.inside-gsm.com/Alcatel/One_Touch_easy_DB/one_touch_easy_db.html)
hi is a hard problem, no soft. try replace power ic whith another one.
this will happen when u use chinese 2 pin chargers, or damaged battery's...
(Dont use fully discharged batteries.., it will permanantly damage ur phone..!)
I had that problem on many phones...it was SW problem,wrong unlock or wrong SW repair.
SHiljo
johnnymld
06-09-2004, 00:13
try to flash it and if is not change ptvl