What do you do if the wires emerging from the pin finder unable to operate Mobile ??!

[hussamaster]

Hello

Observed through my work on the pin finder that the wires emerging from it sometimes unable to operate a mobile and so it was not able to find the Tx & Rx

Therefore, it found a good way to solve this problem by using only negative part of the pin finder As shown in this picture

If you encountered this problem follow this method because it is proven and very successful

Simple way , I believe that some unaware of this method
:) Thank you :)


7sAm MASTER

[InfinitySupport]

Hello,

If phone connected to power all time it's impossible to find pinout.
This method may be useful (but it's quite danger method) if you want to set pinout manually but for automation pinout detection it's not good.
Much better way is to check page 19-20 in PinFinder manual and make required modifications in Unibox.

[asad_nomy7]

good idea bro but one question that the - wire come from phone to pin finder rj45 which pin - or +.because in your pic not clear .i attach the pic plz clearify this.

[hussamaster]

hi asad_nomy7

wire is ( - ) red in photo

[hussamaster]

Hello InfinitySupport

True that the gravity of the process used, but work with me successfully