plz help me urrgent

[ayaz ali]

i always 2 set of china flash with successfully.
but now.
he gave eror.
i try 2 diferent but same....





COM2 [Serial2] selected
Device: Autodetect 6228 NAND
Checking data, wait...
Action: write NAND flash
write: Firmware
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
source data: page only
identification#1 protocol ver: 04
ver. sw1: RATECH28_06A_PCB04_GPRS_MT6228_S02.H808_JV_MP_IP_T OM_1_8T02S0926.BIN
ver. sw2: H808_JV_MP_IP_TOM_1.8T02S0926, 31D7F35E
ffs offset/size: 02000000/02000000
id-page1 Ok
nfi area detection finished: Ok
Boot...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing[6228:8A02:8A02]...
CPU: MT6228
high speed boot enabled
chip: 0031:0000:0101
boot step size: 0400
Release Power button now !
Boot Done
Initialize...
version: 3.0207
loader: 3.748.0
NAND id: ADF1801D
page size: 800+40
pages/block: 40
bits i/o: 08
address cycles: 04
blocks: 0400
ram size: 00800000
NOR: 0000:000000000000 [00000000]
NAND: 00AD:00F10080001D [08400000]
NOR chip is not installed
Initialize Done
Set baud...
921600
Set baud Done
Identification...
reading structure area...
error: unexpected answer:
error: unexpected answer:
error: unexpected answer:
error: unexpected answer:





:confused::confused::confused::confused::confused: :confused:

[InfinitySupport]

You must use HIGH-QUALITY cables based on FTDI chip instead of use buggy Prolific-based cables and boxes !

if you don't have good FTDI based cable you can make "search" in this foirum and find good tested drivers provided by Infinity-Box programmers for repair your low-quality box.
More information you can read here: http://www.gsmhosting.com/vbb/showthread.php?t=476373

[ayaz ali]

You must use HIGH-QUALITY cables based on FTDI chip instead of use buggy Prolific-based cables and boxes !

if you don't have good FTDI based cable you can make "search" in this foirum and find good tested drivers provided by Infinity-Box programmers for repair your low-quality box.
More information you can read here: http://www.gsmhosting.com/vbb/showthread.php?t=476373


i solve this problem use old setup2.45 100% solve

thanx