w200 always stop at stage2!!!!!!!!!!!!!!!!!

[GSMLover2010]

phone accept full flash and red blinking but always stop at stage 2
my TP connection 100% correct
here log:
-- Security Bypass------------------------------------------------------------
User selected phone W200 using Test Point boot mode
Stage 1 started
1) Turn OFF the phone.
2) Connect the phone to DreamBox cable.
Boot Responce = 5A
Processor ID = 8040030101010101 (DB2012 R3A)
EROM Color (BOOT) = 4 : RED
EROM CID (BOOT) = 52
NOR Flash ID = 897E
OTP Status = LOCKED
OTP IMEI = 357354-01-873057-2
OTP CID = 51
EROM Color = 4 : RED
EROM CID = 52
Processing ... \
Hint : Now the probe might be disconnected

Stage 1 completed succesfully
Stage 2 start
Timeout detected
Error : Failed.

I think this version have very bug and supporter relase new update

[GSM_Support]

Please mail all your logs to techaid[at]dreambox.hk.


Best Regards
GSMServer team (www.GsmServer.com)


http://www.gsmserver.com/img/sc_userbar.png

[GSMLover2010]

I found reason for this error:
I tested this phone with V3.5
result show this phone have "Invalid GDFS structure" and with version 3.6 pass the step 1 but in stage 2 alwyse show error ........
I think DREAMGSM TEAM may have remove bugs from v3.6 and repair stages for repairing "Invalid GDFS structure"
see the log with v3.5


-- Security Bypass------------------------------------------------------------
User selected phone W200 using Test Point boot mode
Stage 1 started
1) Turn OFF the phone.
2) Connect the phone to DreamBox cable.
Boot Responce = 5A
Processor ID = 8040030101010101 (DB2012 R3A)
EROM Color = 4 : RED
EROM CID = 52
NOR Flash ID = 897E
OTP Status = LOCKED
OTP IMEI = 357354-01-873057-2
OTP CID = 51
EROM Color = 4 : RED
EROM CID = 52
Hint : Now the probe might be disconnected
Processing ... |
Error : Invalid GDFS structure and/or configuration.
Hint : Try to flash firmware.
Error : Failed.
BR
GSMLOVER

[GSM Dream]

Hello!
Are you use pin 64 for Stage 1?

[GSMLover2010]

Hello!
Are you use pin 64 for Stage 1?

yes
do you want use pin 27 and post result?

[dziii]

testpoint 1 on w200 works ok with 1.5v on needle, but TP 2 needs at least 3.0V (i used ext power supply)
I used old siemens tp cable ,on tp 1 comes 1.5v but on stage of tp2 2.4 v ,so I need solution ,how to get 3.0 volts from box on stage 2

[GSM Dream]

It can be hardware issue.
To dziii
We are not recommend to use any testpoints modification.

[swensonb]

man try to press on/off button on the stage 2 process....

i have successfully my k510 using that trick

post results
regards

[soshan]

my brother
i solve by dream 3,6 problem in k510
thanks dream