PDA

View Full Version : help to repair the gdfs in s500

hooshi
07-19-2008, 13:20
hi
i have problem in repair the gdfs in S500i CID52 can anyone hellp me to clear my problem please help me. please fast... i'm hold........

--- Loading GDFS file----------------------------------------------------------
Loading "D:\DREAM-BOX\Readed GDFS\S500_GDFS\S500_GDFS.dmap"...
Done.
--- Write GDFS-----------------------------------------------------------------
User selected phone S500 using Test Point boot mode
1) Turn OFF the phone.
2) Connect the phone to DreamBox cable.
Boot Responce = 5A
Processor ID = 99000301FFFFFFFF (DB2020 / DB2030)
NOR Flash ID = 2019
OTP Status = LOCKED
OTP IMEI = 353447-02-201859-8
OTP CID = 51
EROM Color = 4 : RED
EROM CID = 52
Hint : Now the probe might be disconnected
Processing ...
Error : Failed.
hooshi
07-19-2008, 15:18
can any one help me???
where is kings
swensonb
07-19-2008, 21:48
you must perform security bypass via TP stage 1&2 located at flash chip....5060MOYOXX...

stage 1 is shown in the pic on DBSS soft pin #2 on small TP area...2nd stage depends on flashchip

regards
swensonb
hooshi
07-20-2008, 05:37
can any one help me to get the stage 2 pin for the M39P0R907 Chip .i want tested pin because all of the pin in pic of DBSS is not work...
help me please....
hooshi
07-20-2008, 06:06
i have problem with stage2 pin ,always... (((I THINK)))

-- Security Bypass------------------------------------------------------------
User selected phone S500 using Test Point boot mode
Stage 1 started
1) Turn OFF the phone.
2) Connect the phone to DreamBox cable.
Boot Responce = 5A
Processor ID = 99000301FFFFFFFF (DB2020 / DB2030)
NOR Flash ID = 2019
OTP Status = LOCKED
OTP IMEI = 353447-02-164237-2
OTP CID = 51
EROM Color = 4 : RED
EROM CID = 52
Hint : Now the probe might be disconnected
Processing ...
Stage 1 completed succesfully
Stage 2 start
Timeout detected
Error : Failed.
harim_1981
07-20-2008, 08:02
see with microscope...pins are in the side of the flash chip....
swensonb
07-20-2008, 16:02
same here i got my S500 always failing at stage 2 tested every single TP on pic but always failed dont know whats happening

i just hope its a bug so next update will be good...

regards
swensonb
GSM Dream
07-22-2008, 13:20
Hello!
Did you try "easy" testpoint?
Try to use this testpoint version (Stage 2 for M39P0R907)
And please, post the results :)