View Full Version : Phone modification (language, firmware)
joejoe202048
08-07-2008, 14:44
Hello everybody
I bought a phone from China. However, it only comes with english language interface and no support for Scandinavian special characters when writing sms messages.
Is there a way for me to install or modify the phone to get the language interface I want and to have support for Scandinavian codepage?
The phone is based on:
ARM9 255MHz processor.
Qualcomm MSM6245 + Philips 6120 platform.
REX Operating System.
Hello everybody
I bought a phone from China. However, it only comes with english language interface and no support for Scandinavian special characters when writing sms messages.
Is there a way for me to install or modify the phone to get the language interface I want and to have support for Scandinavian codepage?
The phone is based on:
ARM9 255MHz processor.
Qualcomm MSM6245 + Philips 6120 platform.
REX Operating System.
some of china device support philips cpu flashing.
but first you nee to find a flash file as same your phone and with add your won language.
though not found, you can add you won language (LP) with flash file. but need LP editor software which is published on market.
after add your won LP with file you can flash your phone with this file than you got what you want.
joejoe202048
08-07-2008, 19:10
>but first you nee to find a flash file as same your phone and with add >your won language.
It is a Verzio Duplii phone. How do I find the flash file for that phone?
>though not found, you can add you won language (LP) with flash file. but >need LP editor software which is published on market.
Do you have a link to a site where I can get this LP editor?
>after add your won LP with file you can flash your phone with this file >than you got what you want.
I am not sure I understand that sentence
Verzio duplii
Bellpepper Twin Bell
General Mobil DST3Gcool
Looks like the same phone.
Maybe someone has the Download Link for Firmware? Please.
Best Regards
joejoe202048
09-06-2008, 21:10
BREW Resource editor generates a .bar file when you compile/build
Is it possible to decompile a .bar file and get the source file ?