View Full Version : plz mr willy
i need your help in some qoustions plz
1- how can i replace PA and antenna switch , and resolder it again .
2- what is the steps Of flashind alcatel DB by andromeda
thanx MR
mahmoud
Replace a parts .....
i used Hakko 850, to set air 6, heater 5, no install any nozzle !
then clean all tin in PCB, and put flux in PA , then put it back , and same setting for hot air . how you remove, same way you install back to PCB !
Antenna switch , 3 and 2.5 enough (151) !
Willy
MR WILLY
YOU MEAN I CAN PICK UP AND PUT IT AGAIN BY HEATING
300C REAGHT ?
Matmoud,
300C, you might heat it so long time :)
what is way your remove parts, it is same way you install too !
Willy
THANX MR WILLY SOO MUCH
BEST REGARDS
MAHMOUD