Problems reading 8310 sec. code using Neelix

[CompleteFone]

Im trying to do this using a data cable but when the phone restarts itself it turns off but never turns back on. Any ideas

[jinn]

use neelix 1.8b <br />and when u connect it should say test mode briefly,then if it does not re boot itself ,press on/off button.<br />and check if configuration settings are correct.<br />it may be on "slow computer"<br />good luck

br<br />jinn

[CompleteFone]

Thanks, i cant use 1.8b cos it wont recognise my authority id calculator, i have the new box with it all built in.<br />I did try powering the phone up when it turned off but wouldnt let me until i disconnected the cable or closed the software?

[jinn]

have u managed to reset phone security?if not try changing configuration.<br />i had same problem but after switching phone off and on and chang config worked ok .<br />also after dct4 fact reset ,leave on for 10 mins before you enter 12345 .

br<br />jinn

[er2000]

1.8b works ok<br />look in the leftcorner of your software when you start<br />i am shure it has 1.8A<br />please download 1.8b from the usergroup<br />this is ok

for the 8310 we tested this and there are no problems whatso ever

[CompleteFone]

Definitely 1.8b, the green light for the authority id just does not show but does with 1.8, strange.