View Full Version : System Failer contact provider on samsungs
Hello M8
I have a lot of samsung phones (a200, N620, N100) that shows ((System Failer contact provider)) massage on it and not related to software.
No water dammage
checked both eep and flash
also change eep IC on them
some has low contrast on lcd
some has default imei and can't change it
any idea?
Really important to me
Please help
Thx & BR
Mehrad
u need to reflash them with good working eeprom .
if the prob. still ........so u need to repair CRC
best regards
mobilemafia
10-29-2002, 06:33
chack board
If we flash the phones with toolbox ver4 the CRC will calculated automatically, am I right?
or any special soft we must do?
I write both flash and eeprom and nothing happends
is there any possibility that check the connection between cpu and eeprom? I think maybe cpu can't read eep content, becouse the imei changes to defualt in these phones
any schematic?
BR
Mehrad
Albarracin
10-29-2002, 21:20
Samsung system failure contac provider repair solution By Nokiaunlocker:
Open Toolbox4
Go into E2pManager
Press Program on
Selec Eeprom
Then E2pTstPattern at the top of the list
Tick the box that says Write to Eeprom
Then in the input box type the following 0x2767
Then Send command to phone
Then press Reset on the right hand site TWICE
The phone should reboot.
Now try a sim in the phone should be working 100%
This was tested on samsung T100 but it should work on Most if not all modells
Regards
its fake
I checked it many times and nothing changed
thx anyway
I solved same problem on two peaces of Samsung T100.
I also thouth that it is software problem and tried many programs for "system failure".
-I cleaned main board with 100% alcohol and soft brash and problem was solved.
sir that wright
if imie is not change
but when imie changed
what solve
write good eeprom anjd original imei
Raheeeeb
08-27-2003, 17:09
hi guys if not soft so its hardware ...
signal processor i c its near to pa
main power regulator
the socket of the power
FractalizeR
08-28-2003, 11:02
I repaired this thing many times by UST. Just buy it at www.vsh-gsm.com. The reason - EEPROM checksum wrong.
hi may any body tell me where i may find toolbox software
please where i may find it
I repaired this thing many times by UST. Just buy it at www.vsh-gsm.com. The reason - EEPROM checksum wrong.
pls where can i get R220 epprom?
murtaza_nns
07-02-2006, 11:19
Hello M8
I have a lot of samsung phones (a200, N620, N100) that shows ((System Failer contact provider)) massage on it and not related to software.
No water dammage
checked both eep and flash
also change eep IC on them
some has low contrast on lcd
some has default imei and can't change it
any idea?
Really important to me
Please help
Thx & BR
MehradTry this one 100% tested.
I have done evrything for Samsung system failer but nothing doing
Pleas tell me about it
makkah mobile
04-19-2007, 15:37
2002 post amazing......................