Jankovic
10-28-2008, 20:48
Hello
Today I get DEAD MP4 G618+ i find right pinout with PINFINDER also find flash on support area the only ONE where is G618 in MT6226 folder
But When I try to write flash i get this ....
COM9 [VCP0] selected
module v2.66
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
eeprom backup enabled, it may takes several minutes !
Action: write NOR flash
"smart write" active
write: Firmware
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
Boot...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing[6226:8A02:8A01]...
CPU: MT6226
high speed boot disabled
chip: 0031:77C1:7426
high speed disabled
boot step size: 0002
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: ACEA80F098E59F:ACEA8000000000
flash: ACEA80F098E59F:ACEA8000000000
number of flash chip/regions detected: 00/01
Unknown or damaged flash chip, operation aborted.
Fault reasons:
1. damaged flash chip: replace or resolder/reball flash chip
2. damaged hardware: check hardware, water inside etc.
3. unknown hardware: set "Advanced chip detection method" box [un-checked] and try again
4. wrong model selection, try 'NAND' selection
Initialize Fail
Finished, time used: 122 sec
Remove/Install battery now !
I try with cheked and un-cheked ADVANCE CHIP DETECTION MODE , but is same ....
Any Other Suggestion will be fine .....
Regrads
Mario
Today I get DEAD MP4 G618+ i find right pinout with PINFINDER also find flash on support area the only ONE where is G618 in MT6226 folder
But When I try to write flash i get this ....
COM9 [VCP0] selected
module v2.66
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
eeprom backup enabled, it may takes several minutes !
Action: write NOR flash
"smart write" active
write: Firmware
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
Boot...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing[6226:8A02:8A01]...
CPU: MT6226
high speed boot disabled
chip: 0031:77C1:7426
high speed disabled
boot step size: 0002
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: ACEA80F098E59F:ACEA8000000000
flash: ACEA80F098E59F:ACEA8000000000
number of flash chip/regions detected: 00/01
Unknown or damaged flash chip, operation aborted.
Fault reasons:
1. damaged flash chip: replace or resolder/reball flash chip
2. damaged hardware: check hardware, water inside etc.
3. unknown hardware: set "Advanced chip detection method" box [un-checked] and try again
4. wrong model selection, try 'NAND' selection
Initialize Fail
Finished, time used: 122 sec
Remove/Install battery now !
I try with cheked and un-cheked ADVANCE CHIP DETECTION MODE , but is same ....
Any Other Suggestion will be fine .....
Regrads
Mario