View Full Version : Fujistar ft-1011
I need information Fujistar TV Mobile Model= ft-1011 dual sim card made in china i need pinout 2 cpu MT6226 and MT6205
I need information Fujistar TV Mobile Model= ft-1011 dual sim card made in china i need pinout 2 cpu MT6226 and MT6205
I have Fujistar picture
InfinitySupport
10-29-2008, 12:01
Hello,
What is bottom connector type ?
Where is GND pin at phone connector ?
Hello,
What is bottom connector type ?
Where is GND pin at phone connector ?
Connector have 12 pin
InfinityHelp
10-29-2008, 19:02
hello!
do you have pinfinder or multimeter?
hello!
do you have pinfinder or multimeter?
I have multimeter, my pinfinder not come yet
InfinityHelp
10-30-2008, 00:13
I have multimeter, my pinfinder not come yet
hello!
1. set multimeter to voltage measuring.
2. check bettery voltage, it should be more than 3,7volts
3. set one multimeter probe to some grounded phone part
(if you cant find grounded part outside phone- you need to take out small thin wire from negative battery terminal)
4. with second probe touch one by one all phone pins (phone battery attached)
(to get better result i would advice to set needle on the end of second probe)
memorise pins with voltage between 2,7-2,9volts.
those are tx/rx
hello!
1. set multimeter to voltage measuring.
2. check bettery voltage, it should be more than 3,7volts
3. set one multimeter probe to some grounded phone part
(if you cant find grounded part outside phone- you need to take out small thin wire from negative battery terminal)
4. with second probe touch one by one all phone pins (phone battery attached)
(to get better result i would advice to set needle on the end of second probe)
memorise pins with voltage between 2,7-2,9volts.
those are tx/rxI have 2,7v in pin 3,7,8,9,10 with cell power
Update in pinout infinity.. tx, rx pin 9 and 10 thanks
my flash is: ver. sw1: MTK26_05C_MASTER_PCB01_GPRS_MT6226_S01.MAUI_05C_W0 6_16.BIN
ver. sw2: MAUI.05C.W06.16, 69F99C39
I would like to know if you want my backup? I would like to know what the file compatible with my unit because it was my turn on and off
when I try to read the flash of error in the middle
InfinityHelp
10-30-2008, 10:27
hello!
please post reading flash error log.
you must start from reading full flash, continue with format FFS complete, restore IMEI.
only after this worth to try flashing
hello!
please post reading flash error log.
you must start from reading full flash, continue with format FFS complete, restore IMEI.
only after this worth to try flashing
After reading full flash, continue with format FFS complete, restore IMEI chip 1 is emergency, chip 2 is ok, imei chip 1 is ok
InfinityHelp
10-31-2008, 22:01
hello!
check if both IMEIs match to IMEI sticker under battery.
for some models this is important for correct work
hello!
check if both IMEIs match to IMEI sticker under battery.
for some models this is important for correct work
imei is correct,
worked for a while but stopped again
InfinitySupport
11-02-2008, 00:05
Hello,
What is the problem exactly ?
Need so detailed problem description as possible.
mendescell
11-27-2008, 15:25
Some friend would EEPROM of the FT-1011 to post here?
Mendescell