urgently need pinout cect gp900 / gp9000

[sario]

Good Day to everyone!

i have here chinaphone CECT gp9000 it's a dual sim phone with GPS module inside and MT6217 chip

I have been trying to connect it to infinity using pinfinder (L5A) but still it won't detect any rx / tx

can anyone share their pinout for this phone..

TIA

br.

http://image.paipai.com/c8b8108f/item-0805F226-1B87370700000000001B36A102E8F0C2.1.jpg

[InfinityHelp]

hello!

most 5pin connector phones keep tx/rx as test points on PCB

[sario]

I found the rx/tx on the pcb it's not located in the mini usb connector as most chinesephone and it does not have any marking for tx or rx. i just tried all the pads until i successfully found it.

http://i12.photobucket.com/albums/a242/sario2k/cectgp9000.jpg


i tried formatting it safe and full format. i also flash the phone with the flash file that i got from the backup. the problem is still the same..

it just keep on restarting after the start up scene.

here's the fullreadflash file i saved before performed the full format because this not found in the support section on infinity..
http://rapidshare.com/files/159545546/flash_cect_gp9000_GPS_MBK6217_05C_PCB01_GPRS_MT621 7_BN.MAUI_05C_W06_16_MP_V25.BIN__20081101-091459.B.html

what will i do next?

[InfinitySupport]

Hello,

1. restore backup
2. make complete format
What is the results ?

Also are you sure that phone has it's original firmware ?

Did you tried to check it's hardware, f.e. rehot/reball CPU (bad soldering is very common problem for this kind of phones) ?