after detect pin out, unable to format ffs!

[syed.n]

software version: 1.17
cable type: 2x7 (L14D)
platform: MT: MT62xx (autodetect)
searching adapter at COM8...
adapter found, version: 2000
pins: 14, plain
power cycles: 1
activation cycles: 5
power-off delay: 20
start Rx/Tx: 1/1
Loading configuration...
Initializing...
Press and HOLD phone Power button now !
detecting pins...
19200 fixed
error: boot initialization step #3 failed:
error: boot initialization step #2 failed: A0
19200 fixed
CPU: MT6226
result: Rx:4 Tx:11
time required: 24 sec
Power On !
.................................................. .............................................
when try to do format ffs.

COM7 [VCP0] selected
module v2.73
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: "format ffs"
Boot ...
Press and HOLD Power button now !
error: can't detect device
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect"
Boot Fail
Finished, time used: 20 sec
Remove/Install battery now !


this cell when switch on keeps restarting
ZTC ZT3328 IS the model.
regards!

[Redtan_70]

check cable mate,,,,, maybe from RX to TX...........

[InfinitySupport]

software version: 1.17
cable type: 2x7 (L14D)
platform: MT: MT62xx (autodetect)
searching adapter at COM8...
adapter found, version: 2000
pins: 14, plain
power cycles: 1
activation cycles: 5
power-off delay: 20
start Rx/Tx: 1/1
Loading configuration...
Initializing...
Press and HOLD phone Power button now !
detecting pins...
19200 fixed
error: boot initialization step #3 failed:
error: boot initialization step #2 failed: A0
19200 fixed
CPU: MT6226
result: Rx:4 Tx:11
time required: 24 sec
Power On !
.................................................. .............................................
when try to do format ffs.

COM7 [VCP0] selected
module v2.73
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: "format ffs"
Boot ...
Press and HOLD Power button now !
error: can't detect device
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect"
Boot Fail
Finished, time used: 20 sec
Remove/Install battery now !

this cell when switch on keeps restarting
ZTC ZT3328 IS the model.
regards!

Hello,

At first double check that phone connector is good and not damaged.

Also try to make "selftest" (see PinFinder manual page 13-14).
Is it possible to PowerOn phone via PinFinder ?