View Full Version : c139 how to remove subsidy pass word
astana2007
01-12-2009, 14:14
I have a motorola c139.
when insert sim card its show subsidy password.
when I press user/phone lock code its work properly,
while I press SP lock.
it doesnt work.
Images r attached.
My Question.
I have to give some heat to its cpu.?????????
I have to cut its test point?????????
or I have to remove its cpu and put again?????
astana2007
01-12-2009, 14:20
here r images.....................
astana2007
01-12-2009, 14:33
also check this section
Just an example: C:\Program Files\InfinityBox\Documentation\Unlock_and_repair\ Fix_Moto-c139_boot_failure[07]_version_mismatch.jpg
InfinitySupport
01-12-2009, 17:44
C:\Program Files\InfinityBox\Documentation\Unlock_and_repair\ Unlock_Moto-C139_TracFone-8.8.17_C113-C118-C123_2.2.83_and_newest.htm
astana2007
01-12-2009, 19:22
3.2. New phone PCB type, need to desolder CPU, remove ball “N1” and continue with instruction below:
Boss I have very weak english language .
according to above instruction I remove cpu and cut N1 and put cpu back again.
now set is not powering on.
I did right or I do something wrong????
InfinitySupport
01-12-2009, 21:21
Hello,
Yes, you are right.
Phone can not power-on after N1 ball was removed.
astana2007
01-13-2009, 08:11
but sir now set i not flashing, nor sp lock is working even not any function is working of software
InfinitySupport
01-13-2009, 17:03
Hello,
After you have removed N1 ball phone can not power-on well but it should be connected with software.
If phone can not be connected with software please double check that you have installed CPU back well.