How to Unlock C123

[Qaisar Mahmood]

How to Unlock C123 . I tried with Cut but Set is Not Attach with Softwere. Plz help me Infinity Team.

[yunaced]

after cutting phone should be dead if not cutting not good or remove n1 ball



1. Open phone and cut track according to test-point picture in “Documentation” folder

2. Now phone can’t power-on but can be connected to software and unlocked/flashed in “Repair mode”

3. If phone still can power-on with cutted track this means that:

3.1. Track cutted not correctly, double check that track cutted well and continue with instruction below:

3.2. New phone PCB type, need to desolder CPU, remove ball “N1” and continue with instruction below:

4. Run “Moto02” module (ver 1.25 or higher)

5. Go to “Settings” page and make “Repair mode” connection box checked

6. If you don't want to restore cutted track back after repair procedure make "Soft restore" cutted track option checked

7. Optional step: make flash backup (read flash) for emergency case

8. Flash phone with the next flash files from support area (letter x means any):

1.x.xx

2.0.xx

2.1.xx

9. Optional step: make "sp-unlock" operation

10. Restore track back (if "Soft restore" cutted track option was not checked during flash operation)


read in your infinity documentation

its is your drive

C:\Program Files\InfinityBox\Documentation\Unlock_and_repair

[InfinitySupport]

How to Unlock C123 . I tried with Cut but Set is Not Attach with Softwere. Plz help me Infinity Team.

Hello,

In some cases it is need to remove CPU ball instead of cut track.
Please, see more information here:
C:\Program Files\InfinityBox\Documentation\Test_point\Moto

[sairat]

after cutting phone should be dead if not cutting not good or remove n1 ball



1. Open phone and cut track according to test-point picture in “documentation” folder

2. Now phone can’t power-on but can be connected to software and unlocked/flashed in “repair mode”

3. If phone still can power-on with cutted track this means that:

3.1. Track cutted not correctly, double check that track cutted well and continue with instruction below:

3.2. New phone pcb type, need to desolder cpu, remove ball “n1” and continue with instruction below:

4. Run “moto02” module (ver 1.25 or higher)

5. Go to “settings” page and make “repair mode” connection box checked

6. If you don't want to restore cutted track back after repair procedure make "soft restore" cutted track option checked

7. Optional step: Make flash backup (read flash) for emergency case

8. Flash phone with the next flash files from support area (letter x means any):

1.x.xx

2.0.xx

2.1.xx

9. Optional step: Make "sp-unlock" operation

10. Restore track back (if "soft restore" cutted track option was not checked during flash operation)


read in your infinity documentation

its is your drive

c:\program files\infinitybox\documentation\unlock_and_repair


thanks very helpful keep it up bro