zab4o
01-08-2003, 22:23
I must uprade T68 to T68i.I make the following steps:
1.Write GDFS.... OK
2.Write AVR ... OK.
3.Write ARM ...... here is the problem, after AVR flashing, my program starts automatically to flash with previously used ARM flash - T68m ARM file...... OK
The results is only blinking red LED and nothing happens, I have try to flash it again but it is not possible- program says "error "
Is there any solution for this problem?
1.Write GDFS.... OK
2.Write AVR ... OK.
3.Write ARM ...... here is the problem, after AVR flashing, my program starts automatically to flash with previously used ARM flash - T68m ARM file...... OK
The results is only blinking red LED and nothing happens, I have try to flash it again but it is not possible- program says "error "
Is there any solution for this problem?