tamper alert is bin prog

[boganice]

well now <br />would you believe that tamper solution is inside<br />roemmi bin?<br />would you give 1000 grand for that? sh#tt

[sloba]

i guess all it does is flexing the right adresses with right values which should also be possible with full emmi.

[cms]

Yes this device cost about 20 $ <img src="biggrin.gif" border="0"> <br />All need:<br />- read eeprom from locked phone<br />- read eeprom from unlocked phone with TAU<br />- compare<br />- make FDF for you EMMI <img src="biggrin.gif" border="0"> <img src="biggrin.gif" border="0"> <img src="biggrin.gif" border="0">

[Own]

hi...ZULEA<br /> I seen problem after tamper alert,i reflash another type phone write phone fail see supplier.Next soon i must buy solution from you.I belive you. <img src="eek.gif" border="0"> <img src="eek.gif" border="0"> <img src="eek.gif" border="0">

[boganice]

i have done my home work <br />and tamper is no more on this roemmi box

just simple dissable routine

thanks to motorolla secret service

[sloba]

for me solution seem 1-1 01 01 01 04 works fine(phone failed)

[asas]

I think that problem is with program. EEPROM bin is ok.

[Pandemonio100]

Yes i think that the problem is the program because the address is changed, you remenber that the same problem whit Ericsson old series and new series? <img src="wink.gif" border="0">

[Invisible]

hi,<br />tamper problem is not about emmi. Emmi is only the interface. The problem is in the program.ok, now comes the interesting part, if you try to flex a new xx.13.xx phone it goes to tamper, so if you flex it even with correct file it will fail. I think that flex is slightly diferent between new firmware xx.13.xx and rest.<br />best regards,<br />Invisible

PS: motorola secret service?,...

[cms]

About C4_13_03:

1. I use full emmi<br />2. Downgrade with testpoint to C4_10_75<br />3. Upload in phone C4_13_03<br />4. Unlock with unlockinguniversal.fdf - without problem<br />5. Reset phone 571#

?????????????????

<img src="confused.gif" border="0">