how to work with 1:1 copy of apple iphone?

[PILONCILLO]

i have one of these:

http://www.diytrade.com/china/4/products/4885793/3G_Iphone_16GB_China_Iphone_1_1_copy_model_phone.h tml#normal_img


http://www.tech-epoch.com/sdp/827994/4/pd-4342630/4981956-1738000.html

all is like original even conector.chargue with original usb but i tunes dont identify.
have some little differences like sim case in original are prsent and in these sim input dicerctly and the reset buttom in side of phone.sw aparence too is like all chinesse phones.

problem is have not signal and cant work with pind finder becouse dont have that conector.

[InfinityHelp]

hello!

lets start from checking what CPU it is based.
you either can do this by disassembling phone or by typing *#0044# and pressing green (send) button.
if you will see "language set: english"- you can be sure, that this phone is supported by Infintiy software

[PILONCILLO]

hello!

lets start from checking what CPU it is based.
you either can do this by disassembling phone or by typing *#0044# and pressing green (send) button.
if you will see "language set: english"- you can be sure, that this phone is supported by Infintiy software

yes is ok.phone say set to english.but what about the conector?
pind finder dont hat that.

[InfinityHelp]

hello!

if phone can be powered from pinfinder power- we can assume that pinfinder failed to find pinout because there is no Tx/Rx in system connector.
now you must look for test points on PCB. for this you might be need to disassemble phone

[PILONCILLO]

no,no,no, i mean these iphone use same conector like original and pin finder dont have any cable like that.then maybe you will need a cable for next productions becouse will be more common.

i think for now only way is try to find the signals using a original usb cable and making the own rj45 cable.(huff .is a lot of work)



if some body have any data about i will be glad.

[InfinityHelp]

hello!

analysing USB cable will not give any result.
better to measure voltages on phone pins and detect Tx/rx by voltage 2,7-2,9 volts.
full charged battery must be attached when you do measurments

[PILONCILLO]

fisrt i need to know if phone have it a 1900 band,but enginering codes dont work.