"TRIOENE" tuch screen problem

[zeerik]

logs are ok but still there is tuch screen text on the LCD:confused:

the mobile name is TRIOENE (MB-100) dual sim it is new firmware and not present in support area


COM20 [VCP0] selected
module v2.81
Action: touchscreen calibration
mode: 3
Model: Autodetect 6205-6227 NOR
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
19200 autodetect
Initializing [6225:8A03:8A00]...
CPU: MT6225
high speed boot On
chip: 0001:8D03:0003
status: FF
Connecting at 19200, wait...
Release Power button now !
Phone detected, wait...
Hardware: MT6225,E03
Date: 2006.06.14
Version: 1.0
Version: E880_EVTST.01.0_25S00
Version: EVEN25_HW
detecting structure #2...
0 done
44 byte(s) read
imei: 35686000883334
connection Ok
detecting structure #5 (mode-3)...
warning: wrong packet cs
done
162 byte(s) read
reading data #2...
writing data...
verification...
verification Ok
Finished, time used: 11 sec
Remove/Install battery now !

[ehsas_ghum]

brother try to use 2.73 chines miracle n then post many user face a problem in new one thanks

[zeerik]

brother try to use 2.73 chines miracle n then post many user face a problem in new one thanks

yes bro.........i have also tried with 2.73 with all the 4 modes turn by turn and also format ffs (safe) but process seems to be ok but there is still text on the LCD :confused:

[InfinityHelp]

hello!

post full firmware version, i will check if it is supported for touchscreen calibration