View Full Version : Error: 0108 in Terminator 1.8
nonu_don
03-29-2003, 08:44
hi, can anyone tell me what is this error for,, ie error 0108 in terminator 1.2 to terminator 2.0
actually i am trying to read codes for my t200 and after 3-4 times of blue bar going to 50% and resets,, this error comes.
plz help me
Naman
nonu_don
03-29-2003, 08:57
weel i must tell that the phone i used (t200) was an unlocked one.
may be this is the reason
Naman
I think not
I readed T200 unlocked and gived me corect codes
I locked back with NCK and unlocked again
BR
Rak|m
*MaTeOoSh*
03-29-2003, 15:48
error 0108 appears when terminator can't bypass boot authority (more precisely - not received expected byte sequence). Just remove battery in phone, put it in and try again - I encountered this problem many times (in fact not in T200 - most in T65) but all solved after some tries ...
Good Luck
nonu_don
03-29-2003, 17:27
thanx,,,
will try it some more time,,,,,
but now error 0101, think pic has fried, but detects dongle and dct4 also works good... dont know whats wrong now
Naman
I had error 0108 few times and always i clean phone conector and then work ok.
Regards
nonu_don
04-02-2003, 13:45
thnx for replying,
will try it when i get a phone to work on..
Naman
nonu_don
04-02-2003, 18:27
no, pin cleaning didnt worked out.
well i got 1 thing
the pins at phone connector that is from 1 to 12, there is continuity in pin no. 2 to pin no. 6 when i connect the dongle to lpt, otherwise no continuity. that is Rx is connected to GND when i connect dongle to lpt port, which is not practicle. i think. this might be the problem, but dont know why is it there.
checked several times
plz help
Naman