Preloader init error: can't get the full back of 8210...plz help?

[the_frightener]

hola folks !

some 1 kindly tell me ...when i try get the back of my 8210 through rolis478... when the software asks for power on the mobile ...n when i do that the rolis478 gives me

"reloader init error:
-phone RAM is bad
-you selected wrong phone type"

while my 8210 is working very fine ...

& when i try to use knok_phoenix_1 ...when it says for power on & when i try to power on the mobile it just powers on n shows the insert sim card ...

what should i do ...?

plz help...

thanx in adv

[GazI]

hi check cabel pins

[the_frightener]

sir ,

that cable is already working on another 8210 ... n this 8210 is also working on Mbus data cable ...


what should i do ...? coz i must have 2 take the back up of flash ...


thanx

[GazI]

hi

@the_frightener

hi what type of cabel are you use flasher cabel or data cabel

for backup you need flasher cabel not datacabel like M/F bus

[the_frightener]

Respected sir,

i'm using the flash cable not a m/f bus cable ... n good news ...


i just put a bit power on the cable when i insert this into my mobile ...n it's working :) wow :)

i've got the back of my 8210 ... now i want 2 convert it into nokia 8250 ...coz i've rom 6 ... so sir plz post a link or tell me where i can get the latest Version of 8250(mcu/ppm) & fresh Eeprom of 8250 ...? but plz do remember i don't wana modified flash ...i wana the original of 8250 ...

i'll be so obliged, if u sir could do so ...

thanx

[GazI]

hi try this

http://www.nokia-zone.tk

[debeliamark]

In some cases to make a successfull flashing on 82x0 and 88x0 with DSP ROM6 you need to connect phone on fast PC - i have one 350 MHz original PII Compaq and never can't do, but on 800MHz PC - work fine. Same situation with 5210. BTW - best way to flash newnest DCT3 is Griffin, but you can't do modifications - Griffin work like original Nokia equipment - mean eeprom R/W is not possible (except to make some trick with *.ini and PPM :D :D :D )