View Full Version : Panasonic G450 cable work???
Nokia man
04-17-2003, 14:18
Hi,
I have purchased a Sharp GX10 clip...so the above doesn't really matter....
But will a G450 cable unlock a sharp gx10 with the free sw...as just like the chargers they have the same connector!
(tested my cable on sharp gx10 and fits perfect!)
This may be of help to the guys in the forum...as the panasonic cables are old and cheap!
Yours Truly
David
Chawkiz_gsm
04-17-2003, 14:22
just use connector of panasonic g450
and mitsubishi aria flash
but not work need change pin and build circuit
mobilephonesgro
04-17-2003, 14:36
Could anybody help? Here is the chance to solve the cable problem.
Panasonic G450/500 connector is almost identical to Sharp connector, it fits perfectly, but the cable will not work without the necessary modifications needed for communication.
Regards,
Jan Farrell
@hakika, I can assure you that any cables sold directly by us are 100% working and tested. It is possible that a faulty cable could be sent to a customer, in which case it would be immediately replaced!
It is also possible you are not using our software correctly: the phone has to be switched on, with or without sim card, with the 9v battery connected. The phone should enter "backup mode" as soon as you hit the "unlock" button. Also note that there is a very old firmware version (0082) that will not enter backup mode, please check this with *01763*8371#. We have only come across 2 handsets with this firmware, is is VERY rare. We can only assure the correct working of the software with Sharp GX-10
Regards,
Jan Farrell
post ammended till further notice-
Strange!
Please accept our apologies if it was due to a faulty cable.
bzpsmachine
04-17-2003, 21:33
Why not use genuine Sharp cable, £24+vat you know you can get that money back from unlocks and it saves a lot of messing about