finally i unlock sharp

[Chawkiz_gsm]

yes i m build > 5 circuit but not work
finally
this is the good work schematics

any cable with tx and rx and gnd but use external power

+5 v -----------resistor10k----- tx pin6
+5 v -----------resistor10k----- rx pin7

i'm use unver box inclided 3.0 gsm factory power supply
or t191 cable

use connector panasonic


connector
pin 1 gnd
pin 2 + pin 10
pin 5 + pin 11
pin 9 + pin 14


+5 v -----------resistor10k----- tx pin6
+5 v -----------resistor10k----- rx pin7


all good phone connect and sty in buckup mode

100000000% unlock after push unlock

tested by chawkiz


icq number if you need any help 178324264

[Chawkiz_gsm]

this is the good work cable


and this is the first unlock sharp

[pez8210]

I TESTED THIS CHAWKI BUT WITH LITTLE MODIFICATIONS AND WORK 1000%

THANK YOU VERY MUCH FOR POST REALITY NOT RUBISH

My working tested probe

1,3 and 14 to GND

2 to 10

tx and rx (6 and ) with 10 k resistor each and connected to 5 V

That´s all works perfect

Thanks chawki again for your inspiration ;)

[Chawkiz_gsm]

good work for all

[paygee]

in ur post [above] pin5 to pin 11

in yahoo group up loaded image shows
pin 5 to pin 12

which 1 is ok

[Chawkiz_gsm]

the good schematics is in yahoo group;)

[olegario]

Cool ! thanks man! I just make one with your schematic!

[paygee]

pin 5 to 11 is also working. tested.