PDA

View Full Version : Unlock Sharp with normal Unlock cable Tested 100%

pez8210
04-19-2003, 13:52
This Is new clear version for make your own unlock cable without pay for special one

Take a unlock cable (I did it with Alcatel Be cable)

Cut the connector you must have 4 wires not 3

Red more or less 5 Vcc

Blue to Tx pin 7

White to Rx pin 6

Black gnd


connect pins 1,3,14 shorted to Gnd black wire

connect pins 2-10 shorted

in pins 7 and 6 you must put 10 k reisitor each and supply them with the red wire


thatīs all 100% really tested

I will try to make an schematic and will post here

Thanks to chawki for the information about

;)
Hams
04-19-2003, 14:01
Good work Pez:)

Hams
Pits
04-19-2003, 14:21
thnkx m8, btw do u use a box like this one ?

http://homepage.vianw.pt/~nx4hbg/box1.jpg
http://homepage.vianw.pt/~nx4hbg/box2.jpg

The pinout u describe is the same so that's why i'm asking. If affirmative do u got full pinouts for this box ? i only got rx tx vcc gnd
datalife2000
04-19-2003, 19:58
@ Pits

i got that box & connections. i opened it inside! get me on ICQ
Pits
04-20-2003, 05:15
i already opened it but had a "hard to remove" grey mass protecting circuit
pez8210
04-20-2003, 08:03
@Pits

If you know RX TX VCC and GND why you want to open this box?

You only have to follow the pin out and buy a Panasonic G450 connector or Mitsubishi Aria
s4sajii
04-22-2003, 11:25
i have tested this cable...work 1000% have unlocked 2 phones so far..

br
Irinel
04-25-2003, 18:17
Originally posted by pez8210
This Is new clear version for make your own unlock cable without pay for special one

Take a unlock cable (I did it with Alcatel Be cable)

Cut the connector you must have 4 wires not 3

Red more or less 5 Vcc

Blue to Tx pin 7

White to Rx pin 6

Black gnd


connect pins 1,3,14 shorted to Gnd black wire

connect pins 2-10 shorted



BIG THNAKS!!!
WORK FINE!!!!
i make 2 phones:)


B.R.

IRINeL
ALFAMOBIL TEAM
ROMANIA
www.ALFAMOBIL.ro

in pins 7 and 6 you must put 10 k reisitor each and supply them with the red wire


thatīs all 100% really tested

I will try to make an schematic and will post here

Thanks to chawki for the information about

;)
pez8210
04-26-2003, 13:09
@ Irinel

Itīs a pleasure for me, try to helping great people as you
;)