3210 contact service - GSM-Forum

scrarfuss · 01-07-2004, 18:31

greetings all i have a 3210 which is sayin contact service i tested it with eeprom tools and it said reason for contact service was .ccont.interface test failed can sum one tell mi wat this means and how to repair the problem thank you

DrMobile · 01-07-2004, 19:59

VISIT http://www.inside-gsm.com/
Here u will be FOUND where is the the LOCATION of Ccont.

Normally this problem can be slove by reflowing it with flux and heat.

Best Regards,
Wahab

drpavlov · 01-08-2004, 02:36

Beware: the CCONT doesen't cause c.s. since it's a power IC. Try to reflash the image, check if eeprom is damaged (or eeprom content), and if neither, then reflux the cobba (or replace) and reflash it, faid, etc...

boil_ice · 02-10-2004, 15:18

i have reflash n reflux the cobba but cant solw the problem....

boil_ice · 02-10-2004, 15:21

Quote:

Originally Posted by DrMobile

VISIT http://www.inside-gsm.com/
Here u will be FOUND where is the the LOCATION of Ccont.

Normally this problem can be slove by reflowing it with flux and heat.

Best Regards,
Wahab

plz tell me more solution about contect servic

Syed · 02-10-2004, 15:43

Quote:

Originally Posted by drpavlov

Beware: the CCONT doesen't cause c.s. since it's a power IC. Try to reflash the image, check if eeprom is damaged (or eeprom content), and if neither, then reflux the cobba (or replace) and reflash it, faid, etc...

dont talk if u dont know !! in 3210 u do get CS from faulty CCONT also... just that u will learn from experience...

@scrarfuss
u can fix ur 3210 by just reballing the CCONT !! if EEPROM tools say this is CCONT interface problem..then it is so !!

WBR
Syed

ionutz808 · 02-12-2004, 22:24

the cobba and ccont have a pin which is called cobba cs and ccont cs the cable can is damaged if not the bgas

boil_ice · 02-23-2004, 15:44

first rebold the cobba then flash if not rebold ccont then full flash.....hope ur problem is sowl

Trion · 03-11-2004, 17:42

If Eeprom tools says its CCONT, reflow it with liquid flux n heat as Dr. Mobile has rightly said. Had same problem. IF it recurs u may need to reball the IC.

Trion

boil_ice · 03-13-2004, 15:48

sir...

my nokia 3210 in some proble i have the charg the battary its still the chargin but after 5 min battary low i have chang the battary but some problem .on the screen display the battary charging but battary not charging

sorry for my bad english

boil_ice · 03-13-2004, 15:51

my nokia 3210 in some proble i have the charg the battary its still the chargin but after 5 min battary low i have chang the battary but some problem .on the screen display the battary charging but battary not charging

sorry for my bad english

bubbles · 05-29-2004, 19:34

TRION YOU CANNOT GET THE CONTACT SERVICE IN CCONT TRY TO READ YOUR MANUAL FIRST AND YOU KNOW THE TRUE

BOIL EYE CHECK YOUR 3210 IN DDP PROG YOU WILL SEE WHAT IS THE FUALT OF YOUR UNIT IF COBBA PARARELL YOU CHANGE COBBA IC IF MCU OR PMM JUST THE WAY TO PUT YOUR PHONE TO THE COMPUTER OR WHAT I MEAN REFLASH IT

BUBBLES

Trion · 06-02-2004, 22:04

Mr Bubbles,

Check all contact service 3210s with eeprom tools...some will show CCONT problem. Forget the manual...reflow the IC and see how it works.....I did it in one case and it worked. I'm not talking through my hat. I specialize in DCT3 CS problems.

Prove it that it can't be possible and then I'll reply.

keany · 07-07-2004, 19:43

is too easy man you must hot or change cconti and all will be ok

Trion · 07-08-2004, 19:04

That's what i was saying, but according to bubbles its "impossible" to get contact service due to CCONT just beacause it hasn't yet happened to him. Perhaps a closer look at the schematics would show him how it is possible.

01-07-2004, 18:31	#1 (permalink)
scrarfuss Freak Poster Join Date: Oct 2003 Location: zimbabwe Age: 41 Posts: 101 Member: 41066 Status: Offline Thanks Meter: 0	3210 contact service greetings all i have a 3210 which is sayin contact service i tested it with eeprom tools and it said reason for contact service was .ccont.interface test failed can sum one tell mi wat this means and how to repair the problem thank you

02-23-2004, 15:44	#8 (permalink)
boil_ice Junior Member Join Date: Jan 2004 Age: 45 Posts: 16 Member: 51151 Status: Offline Thanks Meter: 0	hi first rebold the cobba then flash if not rebold ccont then full flash.....hope ur problem is sowl

03-13-2004, 15:48	#10 (permalink)
boil_ice Junior Member Join Date: Jan 2004 Age: 45 Posts: 16 Member: 51151 Status: Offline Thanks Meter: 0	Drmobil sir... my nokia 3210 in some proble i have the charg the battary its still the chargin but after 5 min battary low i have chang the battary but some problem .on the screen display the battary charging but battary not charging sorry for my bad english

07-08-2004, 19:04	#15 (permalink)
Trion Freak Poster Join Date: Nov 2003 Posts: 370 Member: 44625 Status: Offline Thanks Meter: 36	That's what i was saying, but according to bubbles its "impossible" to get contact service due to CCONT just beacause it hasn't yet happened to him. Perhaps a closer look at the schematics would show him how it is possible. Last edited by Trion; 07-08-2004 at 19:15.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3210 - Contacte service	Moc	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	3	10-07-2001 14:23
3210 CONTACT SERVICE	mudboy	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	9	08-22-2001 02:54
3210 Contact service	Unlocker AL	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	3	04-20-2001 18:09
3210 Contact Service !!??	ceko	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	01-12-2001 04:15
3210 Contact Service	king76	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	08-09-2000 16:07

01-07-2004, 19:59	#2 (permalink)
DrMobile No Life Poster Join Date: Aug 2001 Location: P A K I S T A N _____________ Age: 40 Posts: 3,579 Member: 5932 Status: Offline Thanks Meter: 1,694	VISIT http://www.inside-gsm.com/ Here u will be FOUND where is the the LOCATION of Ccont. Normally this problem can be slove by reflowing it with flux and heat. Best Regards, Wahab

01-08-2004, 02:36	#3 (permalink)
drpavlov Freak Poster Join Date: Apr 2001 Location: Hungary Posts: 192 Member: 3969 Status: Offline Thanks Meter: 9	Beware: the CCONT doesen't cause c.s. since it's a power IC. Try to reflash the image, check if eeprom is damaged (or eeprom content), and if neither, then reflux the cobba (or replace) and reflash it, faid, etc...

02-10-2004, 15:18	#4 (permalink)
boil_ice Junior Member Join Date: Jan 2004 Age: 45 Posts: 16 Member: 51151 Status: Offline Thanks Meter: 0	i have reflash n reflux the cobba but cant solw the problem....

02-12-2004, 22:24	#7 (permalink)
ionutz808 Major Poster Join Date: Jan 2004 Location: romania Age: 49 Posts: 45 Member: 48984 Status: Offline Thanks Meter: 1	the cobba and ccont have a pin which is called cobba cs and ccont cs the cable can is damaged if not the bgas

03-11-2004, 17:42	#9 (permalink)
Trion Freak Poster Join Date: Nov 2003 Posts: 370 Member: 44625 Status: Offline Thanks Meter: 36	If Eeprom tools says its CCONT, reflow it with liquid flux n heat as Dr. Mobile has rightly said. Had same problem. IF it recurs u may need to reball the IC. Trion

03-13-2004, 15:51	#11 (permalink)
boil_ice Junior Member Join Date: Jan 2004 Age: 45 Posts: 16 Member: 51151 Status: Offline Thanks Meter: 0	my nokia 3210 in some proble i have the charg the battary its still the chargin but after 5 min battary low i have chang the battary but some problem .on the screen display the battary charging but battary not charging sorry for my bad english

05-29-2004, 19:34	#12 (permalink)
bubbles Freak Poster Join Date: Feb 2004 Location: under the tree Posts: 161 Member: 55629 Status: Offline Thanks Meter: 6	TRION YOU CANNOT GET THE CONTACT SERVICE IN CCONT TRY TO READ YOUR MANUAL FIRST AND YOU KNOW THE TRUE BOIL EYE CHECK YOUR 3210 IN DDP PROG YOU WILL SEE WHAT IS THE FUALT OF YOUR UNIT IF COBBA PARARELL YOU CHANGE COBBA IC IF MCU OR PMM JUST THE WAY TO PUT YOUR PHONE TO THE COMPUTER OR WHAT I MEAN REFLASH IT BUBBLES

06-02-2004, 22:04	#13 (permalink)
Trion Freak Poster Join Date: Nov 2003 Posts: 370 Member: 44625 Status: Offline Thanks Meter: 36	Mr Bubbles, Check all contact service 3210s with eeprom tools...some will show CCONT problem. Forget the manual...reflow the IC and see how it works.....I did it in one case and it worked. I'm not talking through my hat. I specialize in DCT3 CS problems. Prove it that it can't be possible and then I'll reply.

07-07-2004, 19:43	#14 (permalink)
keany No Life Poster Join Date: May 2004 Location: gsm-land Age: 45 Posts: 755 Member: 67419 Status: Offline Thanks Meter: 237	is too easy man you must hot or change cconti and all will be ok