I can't flash read/write 8210, erase flash error??? - GSM-Forum

Jubri · 03-06-2002, 16:56

I can read/write nothing, the cable it's 100% tested.

Nokia Flasher v1.00b by Dejan:
Loading Boot Loader...
Boot Loader is Ready.
Flash ID:20650F59 <--- ????????????????
Loading Flash Loader...
Flash Loader is Ready.
Erasing Flash...

Erase Flash Error!

Addr:00000000 In:FF Flash:00

Nokia DCT3 flasher by Rolis v5.14:

------------------* Nokia Mobile Info *---------------------------
0000|A1 20 65 0F 59 05 FD 80 12 E0 D6 20 00 24 33 FF |¡ e.Y.ý€àÖ .$3ÿ
0010|FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF 48 |ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿH
0020|2F 8A 24 56 20 20 35 2E 32 36 0A 31 39 2D 31 30 |/Š$V 5.26.19-10
0030|2D 30 30 0A 4E 53 4D 2D 33 0A 28 63 29 20 4E 4D |-00.NSM-3.(c) NM
0040|50 2E 00 20 65 0F 59 00 00 00 00 6F 00 00 00 00 |P.. e.Y....o....
-----------------------------------------------------------------------
SoftWare & HW : V 5.26.19-10-00.NSM-3.(c) NMP.
FLASH TYPE UNKNOWN
-----------------------------------------------------------------------

also:
Nokia Unlocker v7.3
K-rad Nokia Flasher Engine Build 18, Frontends Build 14
[Nokia Tool by Rolis v1.5b]
[Eeprom repair for Nokia DCT3 by Dejan]
[Eeprom Tools by B-phreaks v3.0]

With MBUS i can read info, recalculate faid... but the phone don't work.

Anybody can help me??

gsmsaver · 03-06-2002, 17:22

i think it was file loader problem, try to change your loader, or you can try rolis 4.77 to read and write

[MoOkIe] · 03-06-2002, 18:14

Hi!

If it's not Flash Loader problem, then try this:
- Charge your battery;

Or:

- If phone is dead, take battery out, start the flashing program, when it asks you to turn on the phone, put the battery back on and press NO, if needed... needless to say, you have to have the connector on the phone... :P

Cheers.

Jubri · 03-06-2002, 18:32

gsmsaver@ If it's not Flash Loader problem, i've tested before..

Rolis v4.77: the same problem... unknown flash type

MoOkIe@
i have a doubt, in your second solution:

- If phone is dead, take battery out, start the flashing program, when it asks you to turn on the phone, put the battery back on and press NO, if needed... needless to say, you have to have the connector on the phone... :P

press NO?, where? i try with rolis 4.77 and dejan

Thanks for your reply!!

gsmsaver · 03-06-2002, 21:13

do you know that unknown flash type, it doesn"t mean that you cannot erase it, just because you already erase your firmware, so when you encounter this problem, just press ok, then it will continue erase the flash file, when it was finished, it will upload a new flash file, which means a good full flash backup. after that you phone will bring back life.

[MoOkIe] · 03-07-2002, 01:02

Quote:

Originally posted by [MoOkIe]
Hi!

If it's not Flash Loader problem, then try this:
- Charge your battery;

Or:

- If phone is dead, take battery out, start the flashing program, when it asks you to turn on the phone, put the battery back on and press NO, if needed... needless to say, you have to have the connector on the phone... :P

Cheers.

Hi!

Sorry, i meant ON...

Press power ON...

Also, do you have dejan box? if so use dejan 1.05...
If you don't have dejan box, then try Knok.

Sorry.
Cheers.

Jubri · 03-07-2002, 01:22

Hi

gsmsaver @, what soft do you refer?, with rolan, don´t continue when i press ok.

[MoOkIe] @ I sopose it..

, but it doesn't work

Thaks a lot, for your reply!

Regards.

qtboy · 03-07-2002, 06:54

your flashrom may be defective. try to rework your flash

Abe · 03-07-2002, 07:53

resolder flash chip.....i had this problem too in 3210 and 3310......resoldering with hot air station work 100% by me.......

03-06-2002, 16:56	#1 (permalink)
Jubri Insane Poster Join Date: Mar 2002 Posts: 81 Member: 9945 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	I can't flash read/write 8210, erase flash error??? I can read/write nothing, the cable it's 100% tested. Nokia Flasher v1.00b by Dejan: Loading Boot Loader... Boot Loader is Ready. Flash ID:20650F59 <--- ???????????????? Loading Flash Loader... Flash Loader is Ready. Erasing Flash... Erase Flash Error! Addr:00000000 In:FF Flash:00 Nokia DCT3 flasher by Rolis v5.14: ------------------* Nokia Mobile Info *--------------------------- 0000\|A1 20 65 0F 59 05 FD 80 12 E0 D6 20 00 24 33 FF \|¡ e.Y.ý€àÖ .$3ÿ 0010\|FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF 48 \|ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿH 0020\|2F 8A 24 56 20 20 35 2E 32 36 0A 31 39 2D 31 30 \|/Š$V 5.26.19-10 0030\|2D 30 30 0A 4E 53 4D 2D 33 0A 28 63 29 20 4E 4D \|-00.NSM-3.(c) NM 0040\|50 2E 00 20 65 0F 59 00 00 00 00 6F 00 00 00 00 \|P.. e.Y....o.... ----------------------------------------------------------------------- SoftWare & HW : V 5.26.19-10-00.NSM-3.(c) NMP. FLASH TYPE UNKNOWN ----------------------------------------------------------------------- also: Nokia Unlocker v7.3 K-rad Nokia Flasher Engine Build 18, Frontends Build 14 [Nokia Tool by Rolis v1.5b] [Eeprom repair for Nokia DCT3 by Dejan] [Eeprom Tools by B-phreaks v3.0] With MBUS i can read info, recalculate faid... but the phone don't work. Anybody can help me??

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Nokia 3129 Can't Boot,read,write...	Star75	SpiderMan	0	06-30-2008 16:40
when i write 352256008218176_220000.bif flash to myx-6,erasing flash ..error?	hgjwq	SwS_SaG_BoX	0	02-09-2007 14:28
8210 Erase Flash Error	holek'	Nokia Legacy Phones ( DCT-1 , DCT-2 , DCT-3 , DCT-L )	1	02-24-2002 18:16
Can't read/write 8210 5.27 with dejan! Plz help!	DSB2069	Nokia Legacy Phones ( DCT-1 , DCT-2 , DCT-3 , DCT-L )	31	07-28-2001 21:19
Be3 Flash Read/Write?????	[MoOkIe]	Alcatel & TCL Old Models	2	06-05-2001 19:59

03-06-2002, 17:22	#2 (permalink)
gsmsaver Registered User Join Date: Feb 2002 Location: universal Posts: 102 Member: 9538 Status: Offline Thanks: 0 Thanked 1 Time in 1 Post	i think it was file loader problem, try to change your loader, or you can try rolis 4.77 to read and write

03-06-2002, 18:14	#3 (permalink)
[MoOkIe] No Life Poster Join Date: Mar 2001 Location: Leiria, PT & Macao, CN Posts: 2,524 Member: 3756 Status: Offline Thanks: 0 Thanked 5 Times in 5 Posts	Hi! If it's not Flash Loader problem, then try this: - Charge your battery; Or: - If phone is dead, take battery out, start the flashing program, when it asks you to turn on the phone, put the battery back on and press NO, if needed... needless to say, you have to have the connector on the phone... :P Cheers.

03-06-2002, 18:32	#4 (permalink)
Jubri Insane Poster Join Date: Mar 2002 Posts: 81 Member: 9945 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	gsmsaver@ If it's not Flash Loader problem, i've tested before.. Rolis v4.77: the same problem... unknown flash type MoOkIe@ i have a doubt, in your second solution: - If phone is dead, take battery out, start the flashing program, when it asks you to turn on the phone, put the battery back on and press NO, if needed... needless to say, you have to have the connector on the phone... :P press NO?, where? i try with rolis 4.77 and dejan Thanks for your reply!!

03-06-2002, 21:13	#5 (permalink)
gsmsaver Registered User Join Date: Feb 2002 Location: universal Posts: 102 Member: 9538 Status: Offline Thanks: 0 Thanked 1 Time in 1 Post	do you know that unknown flash type, it doesn"t mean that you cannot erase it, just because you already erase your firmware, so when you encounter this problem, just press ok, then it will continue erase the flash file, when it was finished, it will upload a new flash file, which means a good full flash backup. after that you phone will bring back life.

03-07-2002, 01:22	#7 (permalink)
Jubri Insane Poster Join Date: Mar 2002 Posts: 81 Member: 9945 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	Hi gsmsaver @, what soft do you refer?, with rolan, don´t continue when i press ok. [MoOkIe] @ I sopose it.. , but it doesn't work Thaks a lot, for your reply! Regards.

03-07-2002, 06:54	#8 (permalink)
qtboy Freak Poster Join Date: Feb 2001 Location: davao city, philippines Posts: 112 Member: 3422 Status: Offline Thanks: 1 Thanked 1 Time in 1 Post	your flashrom may be defective. try to rework your flash

03-07-2002, 07:53	#9 (permalink)
Abe No Life Poster Join Date: Apr 2001 Location: Croatia Age: 34 Posts: 1,117 Member: 4185 Status: Offline Thanks: 0 Thanked 3 Times in 2 Posts	resolder flash chip.....i had this problem too in 3210 and 3310......resoldering with hot air station work 100% by me.......