New contact service solution for Nokia 9210i - GSM-Forum

johnny_liang · 08-05-2004, 17:46

today i repair 3 case contact service from 9210i. I check with eeprom tools v 4.0 it says "Eeprom tune checksum error" then I try to move the flash Ic position from the first place to the second place and the second flash ic to the first flash ic and then flash it with UFS tornado, rebuild imei with Mbus cable after that "Contact service" will survive

sorry for bad english, hope this will useful and dont forget to always post your result here thanks

DrMobile · 08-05-2004, 19:35

Solution seem to be usefull..
Thanks for share..

I repaired one 9210 just by FULL FACTORY and UI settings using UFS.. and my phone was become dead.. than I flashed and phone working

100%

Br.

Dave.W · 08-05-2004, 19:38

when u see Eeprom tune checksum error just update sp locks and all is working 100%

johnny_liang · 08-06-2004, 17:49

WELL i think when we upload sp locks CS will gone but after we remove battery and put it back again CS message will show again, it same we install Restart.sis then everytime we remove the batt then put it back again we must run Restart again this not repair 100% of your phone

08-05-2004, 17:46	#1 (permalink)
johnny_liang No Life Poster Join Date: Mar 2003 Location: Nowhere Age: 44 Posts: 636 Member: 25067 Status: Offline Thanks Meter: 81	New contact service solution for Nokia 9210i today i repair 3 case contact service from 9210i. I check with eeprom tools v 4.0 it says "Eeprom tune checksum error" then I try to move the flash Ic position from the first place to the second place and the second flash ic to the first flash ic and then flash it with UFS tornado, rebuild imei with Mbus cable after that "Contact service" will survive sorry for bad english, hope this will useful and dont forget to always post your result here thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need contact service solutions for Nokia 1208.	SUDARSHAN PRASA	Nokia Hardware & Hardware Repair	4	02-22-2010 05:24
1110 new contact service solution	jai2008	Nokia Hardware & Hardware Repair	8	09-13-2008 20:53

08-05-2004, 19:35	#2 (permalink)
DrMobile No Life Poster Join Date: Aug 2001 Location: P A K I S T A N _____________ Age: 40 Posts: 3,579 Member: 5932 Status: Offline Thanks Meter: 1,694	Solution seem to be usefull.. Thanks for share.. I repaired one 9210 just by FULL FACTORY and UI settings using UFS.. and my phone was become dead.. than I flashed and phone working 100% Br.

08-05-2004, 19:38	#3 (permalink)
Dave.W No Life Poster Join Date: Nov 2001 Location: England Age: 41 Posts: 2,821 Member: 7653 Status: Offline Thanks Meter: 823	when u see Eeprom tune checksum error just update sp locks and all is working 100%

08-06-2004, 17:49	#4 (permalink)
johnny_liang No Life Poster Join Date: Mar 2003 Location: Nowhere Age: 44 Posts: 636 Member: 25067 Status: Offline Thanks Meter: 81	WELL i think when we upload sp locks CS will gone but after we remove battery and put it back again CS message will show again, it same we install Restart.sis then everytime we remove the batt then put it back again we must run Restart again this not repair 100% of your phone