1110(i) water damage - GSM-Forum

raghavkumbha · 06-26-2008, 16:46

sir i have a 1110 set which is water damaged n received in dead,after washing it,s shows "contact service",i tried to flash,full erase then flash with 6.00v,but with ufs it's shows "extract content package fail".with jaf after there files(mcu,ppm,cnt)it's shows "can't boot'. sir please help me soon.

raghavkumbha · 06-26-2008, 17:09

i full erase,then flash but same,full clean the board

ashish mobile · 06-26-2008, 17:58

just clean ur pcb with murcury lotion by ultrasonic bath for 10-15 minutes continue after bathing just clean again by aceetone then rehot normally and full erase then only flash (mcu+ppm+pm) ur problem will solve 100% but first try to flash cnt too. (mcu+ppm+cnt+pm) fisrt. (ashish mobile & communication)

06-26-2008, 16:46	#1 (permalink)
raghavkumbha Junior Member Join Date: Nov 2007 Posts: 22 Member: 628996 Status: Offline Thanks Meter: 0	1110(i) water damage sir i have a 1110 set which is water damaged n received in dead,after washing it,s shows "contact service",i tried to flash,full erase then flash with 6.00v,but with ufs it's shows "extract content package fail".with jaf after there files(mcu,ppm,cnt)it's shows "can't boot'. sir please help me soon.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEW [Ultimated Solution]1110,1112,6030,2310,2610 LED problem with water damage	arshad_ali77	Nokia Hardware & Hardware Repair	29	11-02-2008 18:08
NEW [Ultimated Solution]1110,1112,6030,2310,2610 LED problem with water damage	arshad_ali77	Nokia Hardware & Hardware Repair	19	09-19-2008 18:59
1110 water damage	aryan_	Nokia Hardware & Hardware Repair	0	01-11-2008 20:01
1110 dead after water damage	meo786pk	Nokia Hardware & Hardware Repair	8	12-13-2007 09:58
Nokia 1110 water damaged	murtaza_nns	Nokia Hardware & Hardware Repair	1	08-03-2006 11:35

06-26-2008, 17:09	#2 (permalink)
raghavkumbha Junior Member Join Date: Nov 2007 Posts: 22 Member: 628996 Status: Offline Thanks Meter: 0	i full erase,then flash but same,full clean the board

06-26-2008, 17:58	#3 (permalink)
ashish mobile Freak Poster Join Date: Dec 2007 Location: india Posts: 373 Member: 645970 Status: Offline Thanks Meter: 157	just clean ur pcb with murcury lotion by ultrasonic bath for 10-15 minutes continue after bathing just clean again by aceetone then rehot normally and full erase then only flash (mcu+ppm+pm) ur problem will solve 100% but first try to flash cnt too. (mcu+ppm+cnt+pm) fisrt. (ashish mobile & communication)