6260 Doesn't Stay in Local Mode
 

I am working on Nokia 6260 which was DOA (Dead on Arrival). I flashed it with JAF and everything was fine. But upon Factory Settings it failed. After flashing MCU and PPM Nokia Logo Doesn't appeared on LCD. So, I tried heating the ZOCUS (Current Sensor) but still no luck.

Then, I changed it with a working ZOCUS from N6600 (Hope this is the common IC in all WD2 models), reflashed the phone, and nokia appeared on LCD.

But the problem is, within few seconds, local mode disappears. and UI settings fails. After flashing only with MCU and PPM (not UI settings), the phone switch OFF after 30 secs.

Upon Info in JAF, IMIE is ?????????????. Upon Reading UEM in JAF the IMIE is ok but the last digit of IMIE is X.

I can't figure out what exactly is the problem?? Is it UEM or the ZOCUS??

Please help me.

Thanks