6260 sim ic replace - GSM-Forum

totalmanish · 01-06-2007, 06:51

i have a6260 insert sim card .can sombody show be the exact way to remove the mmc socket below which the sim ic is there.....

debeliamark · 01-07-2007, 09:21

The best tool to do this is IR rework station... I was made few pcs using ERSA IR500 as well.

kadirhoca · 01-07-2007, 22:21

Quote:

Originally Posted by totalmanish

i have a6260 insert sim card .can sombody show be the exact way to remove the mmc socket below which the sim ic is there.....

Dear my brother. The 6260 sim ic, same 6100 sim ic. All nokia dct4 sim ic same. If you remove mmc socket, you can see it.
Good luck..

GSM_BLUE · 01-08-2007, 03:36

Quote:

Originally Posted by totalmanish

i have a6260 insert sim card .can sombody show be the exact way to remove the mmc socket below which the sim ic is there.....

remove it one side at a time ... so that the sim socket woudnt damage... you can use hot air with small nossils or solder... then replace or jump sim driver..

wbr

01-06-2007, 06:51	#1 (permalink)
totalmanish Freak Poster Join Date: Aug 2006 Location: akola Posts: 456 Member: 336192 Status: Offline Thanks Meter: 53	6260 sim ic replace i have a6260 insert sim card .can sombody show be the exact way to remove the mmc socket below which the sim ic is there.....

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1110 conact service after replace sim ic	sadafsdkSADAFSD	Nokia Hardware & Hardware Repair	10	07-23-2008 08:14
sim/keypad ic replaced in 1110/1600/2310 C.S	shamsheerdurg	Nokia Digital Core Technology 4 ( DCT-4 )	2	09-19-2007 09:59
6260 display ic fault	hoze!!!	Nokia Hardware & Hardware Repair	0	06-03-2006 10:29
sim ways sim ic 2 uem ic 6230 & 6510	TechPhone	Nokia Hardware & Hardware Repair	0	08-24-2005 00:14
IC replacing	yamaha	Nokia Hardware & Hardware Repair	2	06-17-2003 08:30

01-07-2007, 09:21	#2 (permalink)
debeliamark No Life Poster Join Date: May 2001 Location: Bulgaria Age: 56 Posts: 4,796 Member: 4627 Status: Offline Sonork: 57528:debeliamark Thanks Meter: 1,034	The best tool to do this is IR rework station... I was made few pcs using ERSA IR500 as well.