6610 No Sounds And Vibra - GSM-Forum

mix00 · 06-04-2003, 18:49

hi there!
i have one 6610 water damage.
i clean the pcb and the phone works normaly,but no sounds on buzer and no vibra.

Spike · 06-04-2003, 19:03

Try replacing Buzer or Vibrator and/or Flash MCU & PPM!

bengong · 06-04-2003, 21:05

In my case, my 6610 have no ringtone sound ( the ringtone still exist but there's no sound, only vibrating alert when u receive call ). Speaker is in good condition and i had flashed the phone with mcu ppm several times, not help. This happened once to my nokia 6100 too. Any solutions for this problem ?

Thx in advance

mix00 · 06-05-2003, 09:08

i flash mcu+ppm but no help

bulid · 06-11-2003, 21:13

flash ver 4.74 regards

mix00 · 06-11-2003, 23:11

I DONT THINK THAT ITS SOFTWARE PROBLEM

mutualmobile · 01-10-2006, 05:22

i've the same problem as bengong's one, checking everything is ok, been flashed many different version of firmware, ringtone just doesn't work. any one knows how to repair this problem? thanks!

banalven1 · 01-10-2006, 08:25

try to reball UEM n UPP~~~~~~~~~~~~~~~~~~~~~

mix00 · 01-10-2006, 09:36

under the uem there is a little silver square chip. replace it

mobilepoint · 01-10-2006, 14:57

under the uem there is a little silver square chip. replace it or reball it.......

rajumobile · 01-10-2006, 16:17

That is audio amplifier IC. Just reball or replace it. Also check good connection between buzzer and PCB, if needed make a jumper wire.

naughtycell · 01-11-2006, 02:14

this is the picture of the N150 , the audio power amplefire of the ring polyphonics , it is not - under - the UEM it is below it

SALLAM · 01-11-2006, 03:27

it's woork
but - check bazer ring - or - link borda

gooood naughtycell
hodafone .......

zullu2004 · 01-26-2007, 09:03

have one 6610 with no ring and no vibra
first I change this(pic1) and got sound but still no vibra.
then check this(pic2) and change vibra, but still the same
finally try full flash.
now all ok
earpiece and ring -ok
vibra - ok

so it can be soft problem some times

06-04-2003, 18:49	#1 (permalink)
mix00 Freak Poster Join Date: May 2002 Location: greece Posts: 181 Member: 12417 Status: Offline Thanks Meter: 0	6610 No Sounds And Vibra hi there! i have one 6610 water damage. i clean the pcb and the phone works normaly,but no sounds on buzer and no vibra.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
kg225 no sound and vibra	Amorphes	LG	0	03-28-2008 12:55
E700 No Sound and no Vibra	Pid-Handy-FIt	Samsung Hardware Repair	12	03-05-2007 19:45
E700 - no sound and no vibra after...	marius_gsm	Samsung Hardware Repair	1	06-04-2004 12:45
t600 no mic and vibra	schiavo	Sony Ericsson	0	08-31-2003 23:37
3310 No Light No Sound And No Vibtabing!!!!!!!!	robbiesl42	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	12-31-2002 02:20

06-04-2003, 19:03	#2 (permalink)
Spike Freak Poster Join Date: Jan 2003 Posts: 114 Member: 20584 Status: Offline Thanks Meter: 0	Try replacing Buzer or Vibrator and/or Flash MCU & PPM!

06-04-2003, 21:05	#3 (permalink)
bengong Freak Poster Join Date: Jul 2002 Location: PA Age: 45 Posts: 160 Member: 13453 Status: Offline Thanks Meter: 3	In my case, my 6610 have no ringtone sound ( the ringtone still exist but there's no sound, only vibrating alert when u receive call ). Speaker is in good condition and i had flashed the phone with mcu ppm several times, not help. This happened once to my nokia 6100 too. Any solutions for this problem ? Thx in advance

06-05-2003, 09:08	#4 (permalink)
mix00 Freak Poster Join Date: May 2002 Location: greece Posts: 181 Member: 12417 Status: Offline Thanks Meter: 0	i flash mcu+ppm but no help

06-11-2003, 21:13	#5 (permalink)
bulid Freak Poster Join Date: Feb 2003 Location: macedonia Age: 44 Posts: 313 Member: 22040 Status: Offline Thanks Meter: 2	flash ver 4.74 regards

06-11-2003, 23:11	#6 (permalink)
mix00 Freak Poster Join Date: May 2002 Location: greece Posts: 181 Member: 12417 Status: Offline Thanks Meter: 0	I DONT THINK THAT ITS SOFTWARE PROBLEM

01-10-2006, 05:22	#7 (permalink)
mutualmobile Freak Poster Join Date: May 2005 Location: New Zealand Posts: 175 Member: 146818 Status: Offline Thanks Meter: 7	i've the same problem as bengong's one, checking everything is ok, been flashed many different version of firmware, ringtone just doesn't work. any one knows how to repair this problem? thanks!

01-10-2006, 08:25	#8 (permalink)
banalven1 Freak Poster Join Date: Nov 2005 Location: Malaysia Age: 43 Posts: 458 Member: 202941 Status: Offline Thanks Meter: 85	try to reball UEM n UPP~~~~~~~~~~~~~~~~~~~~~

01-10-2006, 09:36	#9 (permalink)
mix00 Freak Poster Join Date: May 2002 Location: greece Posts: 181 Member: 12417 Status: Offline Thanks Meter: 0	under the uem there is a little silver square chip. replace it

01-10-2006, 14:57	#10 (permalink)
mobilepoint No Life Poster Join Date: Nov 2005 Posts: 554 Member: 201343 Status: Offline Thanks Meter: 26	under the uem there is a little silver square chip. replace it or reball it.......

01-10-2006, 16:17	#11 (permalink)
rajumobile No Life Poster Join Date: Feb 2004 Age: 52 Posts: 593 Member: 54993 Status: Offline Thanks Meter: 47	That is audio amplifier IC. Just reball or replace it. Also check good connection between buzzer and PCB, if needed make a jumper wire.

01-11-2006, 03:27	#13 (permalink)
SALLAM Freak Poster Join Date: Nov 2004 Age: 39 Posts: 261 Member: 92061 Status: Offline Thanks Meter: 3	it's woork but - check bazer ring - or - link borda gooood naughtycell hodafone .......