8910i power on/off problemm - GSM-Forum

vladutstoian · 10-25-2004, 14:54

I have one 8910i who have the PCB damaged under on/off power and don
't power up but the phone work 100% I put it in the flash dongle and I power it in normal mode and works. I need a solution to connect the switch to a other part of the PCB.I can't use R301 (4k7) because the PCB was hitted in that part and I need another point to connect the power switch.

willy · 10-25-2004, 16:59

if R301 and C312 can not help you ,
then remove UEM, connect a wire from pin "P7" to switch !

Willy

10-25-2004, 14:54	#1 (permalink)
vladutstoian Crazy Poster Join Date: Feb 2004 Age: 39 Posts: 58 Member: 53969 Status: Offline Thanks Meter: 2	8910i power on/off problemm I have one 8910i who have the PCB damaged under on/off power and don 't power up but the phone work 100% I put it in the flash dongle and I power it in normal mode and works. I need a solution to connect the switch to a other part of the PCB.I can't use R301 (4k7) because the PCB was hitted in that part and I need another point to connect the power switch.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
W350i low voltage on power on/off	asmanju08	Sony Ericsson Hardware Repair	0	10-09-2009 05:51
Is there any solution for T39 with power on/off always	Stoyan	Old Ericsson Phones & Sony Phones	9	10-07-2003 01:15
8850 power on/off	joe locks	Nokia Hardware & Hardware Repair	7	09-24-2002 03:06
6210 power-on-off-on-off	Safrane	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	5	07-20-2002 15:55
N3210 powers ON-OFF automatically when is on charger!?!	MaRiN	Nokia Hardware & Hardware Repair	1	12-24-2001 00:31

10-25-2004, 16:59	#2 (permalink)
willy No Life Poster Join Date: Mar 2000 Location: inside NOKIA phone Age: 58 Posts: 1,677 Member: 1060 Status: Offline Thanks Meter: 10	if R301 and C312 can not help you , then remove UEM, connect a wire from pin "P7" to switch ! Willy