change nokia model to another

[tahir rafiq]

3100b rh50 to 3100 rh19


flash it with rh19


write 3100 special pm file for speaker



ui settings.

[tahir rafiq]

3200b to 3200

only change filters and write good pm file.

[tahir rafiq]

3600 to 3650


change filters

flash the phone with 3650 flash files v3.16 ,write good pm and ui settings.

[tahir rafiq]

8390 to 8310

1. Jumper resistor is a resistor (not actually a resistor) with 0 ohm value, usually colored green with 0 markings.
Wire can also be use instead, but must not be very thin and should be as short as possible. Thin and long wire will introduce high inductive reactance and will result to weak received signal.

2. T500 can be taken from 3310 unit. It is located just above HAGAR, refer to your service manual to easily locate it. Also take note to its pin orientation during installation.

Bypassing Z551 with wires is not recommended,this will weaken the receiver sensitivity due to incorrect signal phase relationship.

3. Give special attention when installing VCO, improper positioning will result to no network activity

[tahir rafiq]

6800a to 6800

do as in picture.

[tahir rafiq]

ngage qd rh47 to ngage qd rh29

DO HARDWARE AS SHOWN IN PICTURE.


1- Erase
2- Flash MCU and PPM (Ngage Qd Rh-29)
3- Write pm
4- Init lock

[tahir rafiq]

6102 TO 6101

FOLLOW THE PICTURE.

[tahir rafiq]

2651 TO 2650


CHANGE FILTERS,FLASH WITH 2650 FLASH FILES AND WRITE GOOD PM FILE.

[tahir rafiq]

here is nokia 3390b to 3310 converting solution.


full flash with 3310 firmware and do hardware like in picture.

[tahir rafiq]

6010 to 3510i Convertion

[tahir rafiq]

6030b to 6030






Procedure:

1. like RM225 (6030b) convertion jumper or change two filters
2. write good pm 6030.pm
3. full UI settings anf unlock
riders is offline Reply With Quote

[tahir rafiq]

1100b-1100




Procedure:

1. erase flash
2. flash with 1100(rh18)
3. change filters
4. write pm
5. unlock

[tahir rafiq]

1110-1600

Procedure:

Convert Nokia 1110 (RH-70) to 1600 (RH-64) (display)

Replace the display module from 1110 with coloured module from 1600.

Flash the phone with 1600 flash files and make full factory reset.

Its not neccessary to flash the phone with 1600 flash files,

if you don't have flash equipment!

[tahir rafiq]

Convert Your Nokia BB5 Phones (850/950 mhz to 900/1800 mhz)

Also now you can convert 5200b to 5200 to work on 900mhz and using HWK , BOOM.


Rm-174_CCCCmt.bin
Rm-174_HWCCmt.bin
from option CERT .
That's all and now your phone work 100%

and if you have phone 5300b need to convert it to 5300 regular

Rm-146_CCCCmt.bin
Rm-146_HWCCmt.bin


and your phone now converted sucessfully
NB : Please make backup 308.1 pm and RPL before doing any thing .

[tahir rafiq]

6030b to 6030

1. Change the rx filter 6030b got it any other phone(nokia 3100)
2. Full flash with 6030 files(Mcu+ppm+cnt)
3. Write a good pm
4. unlock