new N6210 network first going on then dropped
 

Hi! friends,

I have strange problem in 6210, 3310 3330 phones. After turned on the network is full then passed few seconds it is dropped. after that never found network. I changed the software, ID, hardware chips in RF circuit but no success. Any idea or solution for it, Please, advice me.

Best wishes, Ganaa
[email protected]

Dgtulga

Check your antenna swirch first , and reball cobba !
then check at TX power output !

Willy

HI!

All is already changed by new one

dgtulga

now, you have to measure phone !

first, you use oscilloscope , to see TX IP/QP from COBBA to Hager,
see that wave all correct ? and check TXP and TXC !

and you use multi meter ( or oscilloscope ) to test VTX , and VCP
and all Vxx for Hager

and use wintesla to set TX power level on 5, and measure that PA out going is working at 32bdm or not

then check TXDET path to Hager !
then check Antenna !


Willy

hi willy, i usually just check tx via netmonitor.. I'm already beginning to be good at it in 33, 8x, 62... not quite on 51 and 32 :)

II want to know if these works on cracked wintesla? I have read your previous posts and reqad the manual(Wintesla Manual) but still get and error...


or can we tune the phone after replacing "major" ic's on cracked wintesla? I want to give the phone at its best state not just "With Network" :)

trafix,,

why not you use get one PKD-1, and save your all wintesla problem , since it is not expensive !
and cloned already for sell ,,, ( ask spear)!

netmoniter is helpful ,, but it can not tell you, that which parts is "dead" ,,,,
you only can know,, how is RX, and TX (yes or no) !

measure phone is correct way to do it :)
if you interested, i can teach you in my office ,, just mail me !

Willy