nokia c2-00 dead help me - GSM-Forum

buntyverma · 04-19-2013, 06:12

nokia c2-00 dead help me urjent

mahzra azra · 04-19-2013, 09:36

Quote:

Originally Posted by buntyverma

nokia c2-00 dead help me urjent

clean pcb with petrol and wash it and dry it .heat power and flash with past,a good heating.
now chek with battery if set dead connect to pc and do softwarte. post reply

sachin oza · 04-19-2013, 09:46

chake lcd concation or change lcd

tolga02 · 04-22-2013, 21:25

Do you have the software and then try to measure the short-circuit

citycellworld · 04-26-2013, 15:06

see lcd soldring ways care fully ,,,,tracks broken just jumpers apply,,,try this,,,,,

ABUU YUUNUS · 04-26-2013, 15:22

On the 12-line display/light track, tracks 2,3,5,6,7, and 8 are very crucial to LCD display while 10 and 11 are for light, the remaining 1,4,9 and 12 are ground. So check for open circuitry in the display lines in particular. By open circuit I mean discontinuity in the track or break in the line as against what some people just coined from their mind and call it shorting while this means an illegal connection between electrical points which leads to increased power consumption in most cases.

tolga02 · 04-28-2013, 14:28

Quote:

Originally Posted by tolga02

Do you have the software and then try to measure the short-circuit

Did you try a friend

04-19-2013, 06:12	#1 (permalink)
buntyverma Freak Poster Join Date: Aug 2011 Location: india Posts: 160 Member: 1646089 Status: Offline Sonork: 1605550:77711 Thanks Meter: 14	nokia c2-00 dead help me nokia c2-00 dead help me urjent

04-19-2013, 09:46	#3 (permalink)
sachin oza Insane Poster Join Date: Aug 2010 Location: INDIA Posts: 75 Member: 1371631 Status: Offline Sonork: [email protected] Thanks Meter: 18	chake lcd concation or change lcd

04-22-2013, 21:25	#4 (permalink)
tolga02 Freak Poster Join Date: Oct 2006 Location: (((TÜRKİYE))) Posts: 169 Member: 371390 Status: Offline Thanks Meter: 21	Do you have the software and then try to measure the short-circuit

04-26-2013, 15:06	#5 (permalink)
citycellworld Registered User Join Date: Jun 2007 Posts: 58 Member: 521568 Status: Offline Thanks Meter: 11	see lcd soldring ways care fully ,,,,tracks broken just jumpers apply,,,try this,,,,,

04-26-2013, 15:22	#6 (permalink)
ABUU YUUNUS No Life Poster Join Date: Jul 2006 Location: IBADAN, OYO STATE, NIGERIA Posts: 724 Member: 319112 Status: Offline Thanks Meter: 164	On the 12-line display/light track, tracks 2,3,5,6,7, and 8 are very crucial to LCD display while 10 and 11 are for light, the remaining 1,4,9 and 12 are ground. So check for open circuitry in the display lines in particular. By open circuit I mean discontinuity in the track or break in the line as against what some people just coined from their mind and call it shorting while this means an illegal connection between electrical points which leads to increased power consumption in most cases.