Nokia Hardware Picture, Help In One Page [solution] - Page 21 - GSM-Forum

Jeab_1 · 02-22-2007, 14:43

It's good job...........thanks.

jaffar_ahamed · 02-24-2007, 07:12

u did agreat job man and its cool

MAJESTIC PIRATE · 02-24-2007, 18:21

good work man although link is forbidden or not working..........

mutlutuna · 02-25-2007, 10:43

thenk you very match..braaaaaaavo

sKy_tRo · 02-25-2007, 15:54

great job man

it will helps a lot.

thank you and more power...

ANVER · 02-25-2007, 17:09

give me diagrame... i am new

a_man · 02-25-2007, 21:06

help
i have 6100 beside the power switch there is 2 resistor that link was missed
i need to connect them or find some way to connect the power switch so the phone power on
is there any way to know it's links or to bridge them
thanks

Javed ajmeri · 02-26-2007, 06:35

hi............
I have 7610. It has display problem.i replace display ic but it's not working & also no voltage on on/off switch.i check the power line.it's ok .pls help me.

ttkul · 02-26-2007, 06:49

Quote:

Originally Posted by ..::ArchitRaj::..

Here Is New Links 01 - 02

Br

Archit Raj

prof,
nid schematics n73 for signal problem
tnx in advance

Hizkia · 02-27-2007, 05:46

Quote:

Originally Posted by ..::ArchitRaj::..

Now All Links OK
6800 insert sim.

Br

Archit Raj

my sim sitting has been ripped off the board,plss anybody with knowlegde of the simways should plss post here.

samanthe · 02-27-2007, 06:42

hi friends,
I have one of nokia 6280...after full charge it can use ony 2 hours maximum...battery down quickly,I was replaced PA,and changed with ather battery also..but it is same,
please if sombody knows about this problem....pls reply to me,
best regards,
samanthe

abuthuraya · 02-27-2007, 20:59

Please can any body tall me about 1100 not charging?

zaki537 · 02-27-2007, 23:17

change ic or make jamper

mega ohm · 02-28-2007, 04:07

Quote:

Originally Posted by a_man

help
i have 6100 beside the power switch there is 2 resistor that link was missed
i need to connect them or find some way to connect the power switch so the phone power on
is there any way to know it's links or to bridge them
thanks

Hi , Dose you lost that resistor and capacitor beside the power switch too ? If No ... Try make jumping with this sulotion in picture below .

BR,

Mega Ohm

mega ohm · 02-28-2007, 04:24

Quote:

Originally Posted by Javed ajmeri

hi............
I have 7610. It has display problem.i replace display ic but it's not working & also no voltage on on/off switch.i check the power line.it's ok .pls help me.

Hi , Make sure all circuits is link with LCD connector .

BR,

Mega Ohm

02-25-2007, 21:06	#307 (permalink)
a_man Junior Member Join Date: Oct 2001 Location: egypt Posts: 24 Member: 6733 Status: Offline Thanks Meter: 0	6100 power switch links help i have 6100 beside the power switch there is 2 resistor that link was missed i need to connect them or find some way to connect the power switch so the phone power on is there any way to know it's links or to bridge them thanks

02-27-2007, 06:42	#311 (permalink)
samanthe Freak Poster Join Date: Oct 2003 Posts: 139 Member: 41791 Status: Offline Thanks Meter: 4	6280 battery drain fast hi friends, I have one of nokia 6280...after full charge it can use ony 2 hours maximum...battery down quickly,I was replaced PA,and changed with ather battery also..but it is same, please if sombody knows about this problem....pls reply to me, best regards, samanthe

02-27-2007, 20:59	#312 (permalink)
abuthuraya Junior Member Join Date: Feb 2007 Posts: 1 Member: 444625 Status: Offline Thanks Meter: 0	abuthuraya Please can any body tall me about 1100 not charging?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sony Erricson Hardware Picture Here in one link	shahabuddin	Sony Ericsson Hardware Repair	25	04-04-2013 02:56
Sony ericson hardware picture all in one	caferimm68	Sony Ericsson Hardware Repair	9	01-19-2012 15:56
Sony ericson hardware picture all in one !	.:DR.APE:.	Sony Ericsson Hardware Repair	21	12-03-2011 08:29

02-22-2007, 14:43	#301 (permalink)
Jeab_1 Junior Member Join Date: Dec 2006 Posts: 5 Member: 403887 Status: Offline Thanks Meter: 0	It's good job...........thanks.

02-24-2007, 07:12	#302 (permalink)
jaffar_ahamed Freak Poster Join Date: Jul 2006 Location: chennai,india Posts: 171 Member: 309499 Status: Offline Thanks Meter: 11	u did agreat job man and its cool

02-24-2007, 18:21	#303 (permalink)
MAJESTIC PIRATE Freak Poster Join Date: Dec 2003 Location: E G Y P T Age: 47 Posts: 336 Member: 45635 Status: Offline Thanks Meter: 20	good work man although link is forbidden or not working..........

02-25-2007, 10:43	#304 (permalink)
mutlutuna Junior Member Join Date: Aug 2006 Posts: 2 Member: 335777 Status: Offline Thanks Meter: 0	thenk you very match..braaaaaaavo

02-25-2007, 15:54	#305 (permalink)
sKy_tRo Junior Member Join Date: Mar 2003 Location: Philippines Posts: 35 Member: 24122 Status: Offline Thanks Meter: 4	great job man it will helps a lot. thank you and more power...

02-25-2007, 17:09	#306 (permalink)
ANVER Banned Join Date: Jan 2005 Age: 46 Posts: 9 Member: 102525 Status: Offline Thanks Meter: 2	give me diagrame... i am new

02-26-2007, 06:35	#308 (permalink)
Javed ajmeri Freak Poster Join Date: Jan 2007 Location: vadodara,gujarat,india Posts: 244 Member: 424082 Status: Offline Thanks Meter: 128	hi............ I have 7610. It has display problem.i replace display ic but it's not working & also no voltage on on/off switch.i check the power line.it's ok .pls help me.