I need your help friends - GSM-Forum

GSM Deals · 01-23-2002, 19:08

i have a chineese emmi-box which is detected with motflex 8.5 as "motorola flash programmer 62.50.00 i can not see how much memory it has on board.my problem with it is that i can not flash a tampered V2288 every time the box starts perfoming and sending flash commands the phone powers off and disconnect from emmi and nothing else happens on terminal window.note that i successfully upgraded v3690 with this same box regards

kenichi · 01-24-2002, 06:34

It is an xx.13.xx. I have no experience with Motoflex, but you need to use the testpoint to flash the phone.

GSM Deals · 01-24-2002, 11:13

where is located te test point on V2288 board i could not find any tp near the flash chip please help regards

GSM Deals · 01-24-2002, 18:03

Ok gays i find out the test point.it's just below flash chip ander metalic cover first i tested with 3.6V from battery through 100ohm resistor and nothing then i noticed that the emmi is equipped with special hadware for test point i connected it and then flash and flex was performed well Megaslava and vadim regards

01-23-2002, 19:08	#1 (permalink)
GSM Deals No Life Poster Join Date: Apr 2001 Location: Morocco Agadir Posts: 1,365 Member: 3936 Status: Offline Thanks: 57 Thanked 191 Times in 85 Posts	I need your help friends i have a chineese emmi-box which is detected with motflex 8.5 as "motorola flash programmer 62.50.00<br />i can not see how much memory it has on board.my problem with it is that i can not flash a tampered V2288 every time the box starts perfoming<br />and sending flash commands the phone powers off and disconnect from emmi and nothing else happens on terminal window.note that i successfully upgraded v3690 with this same box<br />regards

01-24-2002, 11:13	#3 (permalink)
GSM Deals No Life Poster Join Date: Apr 2001 Location: Morocco Agadir Posts: 1,365 Member: 3936 Status: Offline Thanks: 57 Thanked 191 Times in 85 Posts	where is located te test point on V2288 board i could not find any tp near the flash chip please help<br />regards

01-24-2002, 18:03	#4 (permalink)
GSM Deals No Life Poster Join Date: Apr 2001 Location: Morocco Agadir Posts: 1,365 Member: 3936 Status: Offline Thanks: 57 Thanked 191 Times in 85 Posts	Ok gays i find out the test point.it's just below<br />flash chip ander metalic cover first i tested with<br />3.6V from battery through 100ohm resistor and nothing then i noticed that the emmi is equipped<br />with special hadware for test point i connected it and then flash and flex was performed well Megaslava and vadim<br />regards

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Help of foreign friends, I need your help. . .	zhangheng	Nokia Multimedia	0	03-07-2010 03:16
Help of foreign friends, I need your help. . .	zhangheng	Nokia Digital Core Technology 4 ( DCT-4 )	0	03-07-2010 03:15
Help of foreign friends, I need your help. . .	zhangheng	Nokia Legacy Phones ( DCT-1 , DCT-2 , DCT-3 , DCT-L )	0	03-07-2010 03:15
NOW I NEED YOUR HELP FRIENDS.	Pandemonio100	Old Legacy Motorola (EMMI)	5	01-22-2002 16:24
Please FRIENDS i need your help!!!!	Pandemonio100	x1x to x45/x50	1	06-28-2001 14:00

01-24-2002, 06:34	#2 (permalink)
kenichi No Life Poster Join Date: Aug 2001 Location: Madrid (from here to heaven) Age: 31 Posts: 814 Member: 6084 Status: Offline Thanks: 0 Thanked 4 Times in 4 Posts	It is an xx.13.xx. I have no experience with Motoflex, but you need to use the testpoint to flash the phone.