got code from C330 with passo but wont unlock - GSM-Forum

douda · 07-04-2003, 23:58

i readed code from C330 but when i put it
phone dont says wrong code but stays contact provider and always 30 waiting mns

jaleo · 07-05-2003, 03:05

same with me...

Passo finally works but the eight digit code (subsidiary code) that gives is wrong for my operator... i will try again...

Tested with:

Windows 98SE
Motorola PST 6.0
MSS 3.2.3 Cracked extracted to a folder with the following files:
Flash.exe only (Motorola Flasher Software 9.9.9 cracked by SPunlock)
Passo.exe only (cracked by SPunlock)

Start [Flash.exe] and later [Passo.exe]

motorola c333 with firmware TA02_G_06.04.22R unlock edition.

Works 100%

...

aliwali · 07-05-2003, 03:39

pass to my office near u about 02 mns by taxi and u can unlock with clip

jaleo · 07-05-2003, 03:45

I tried again with Passo and give me different code!!! It's normal?
Of course the new code doesn't work with my provider... so i decide to finish the test because I don't want to lock the phone

Thanks to SPunlock for cracking this software... but it's terribly buggy and doesn't works for me (I hope others can).

douda · 07-05-2003, 09:38

for me the same code is generated 20 times !!

TriggaHappy · 07-05-2003, 18:43

I'm having problems installing the P2k Drivers under WIN98...

On XP they work fine, but in 98 I end up having 2 or sumtimes 3 Motorola USB Modems.

Any ideas?

Logslander · 07-05-2003, 19:34

do you test with clip?

Brka · 07-05-2003, 23:13

yeah ...
and did you flashed phone with unlock flash before reading codes ?????

b.r.
ALex.

jaleo · 07-07-2003, 02:24

...finally Passo works!!! (me again)

(even if you lock your phone and "Contact Service Provider" message appears in the screen)

After flashing with the correct unlock flash, remove the original provider SIM and enter the SIM of the other provider you want to unlock... enter the PIM and connect the phone... start Motoflasher and later Passo and clic "SEARCH"... the program start a brute force attack to find the correct code and finally gives it (the time for this process will vary).

But if the code doesn`t work, try again (even if you finally lock the phone and "Contact Service Provider" appears)... simply wait 50 minutes and this message dessapears... then repeat the whole process again.

In my first test the code that gave Passo was wrong and with later test (3 intents) I only obtained the damned message "Contact Service Provider" but finally the last code works.

I use the P2K driver that PST install but you can use this:
http://lggroup.cjb.net/down/p2k_driver_1.33.zip

I know is hard to install and setup these programs but they works... believe me...

Thanks SPunlock

douda · 07-07-2003, 10:25

what unlock flash did you used??
and please post link for download
thanks

jaleo · 07-07-2003, 17:57

For c33x I use this unlock edition firmware:
http://lggroup.ajolote.net/down/TA02...unlock.vfl.rar

Password: lggroup.cjb.net

Anybody knows the unlock edition firmware for c35x?

Thanks

the_frightener · 07-08-2003, 09:02

jaleo

hola amigo

my uncle send me C350 from uk ... i'm having the same problem "enter subsidy code" ...i've also have a mini usb data cable of c330 ...but i don't have any soft like Motorola PST 6.0
MSS 3.2.3 Cracked Flash.exe only (Motorola Flasher Software 9.9.9 cracked by SPunlock)
Passo.exe only (cracked by SPunlock)

so plz tell me the link for the soft n plz also guide me to solve this problem ... ...

i'll be so obliged, if u amigo could do so...

Gracias

jaleo · 07-09-2003, 00:44

To unlock the c350 with Passo searcher you need the unlock edition firmware for c350... nowadays only exits for c33x & t720 ... I hope somebody release this type of firmware for c350.

To download all stuff (Passo and Motoflasher) simply connect to http://www.spunlock.com

Best Regards.

GSMVN · 10-30-2003, 22:43

Anybody has the Unlock FW for C350 ?? Pls share ...

Thanks !

bakarioss · 11-02-2003, 22:49

www.gsfactory.com

07-04-2003, 23:58	#1 (permalink)
douda Freak Poster Join Date: Jan 2002 Location: Tunisia Posts: 212 Member: 8903 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	got code from C330 with passo but wont unlock i readed code from C330 but when i put it phone dont says wrong code but stays contact provider and always 30 waiting mns

07-05-2003, 03:05	#2 (permalink)
jaleo Insane Poster Join Date: May 2003 Location: Spain Posts: 65 Member: 29370 Status: Offline Thanks: 4 Thanked 2 Times in 2 Posts	same with me... Passo finally works but the eight digit code (subsidiary code) that gives is wrong for my operator... i will try again... Tested with: Windows 98SE Motorola PST 6.0 MSS 3.2.3 Cracked extracted to a folder with the following files: Flash.exe only (Motorola Flasher Software 9.9.9 cracked by SPunlock) Passo.exe only (cracked by SPunlock) Start [Flash.exe] and later [Passo.exe] motorola c333 with firmware TA02_G_06.04.22R unlock edition. Works 100% ... Last edited by jaleo; 07-05-2003 at 03:20.

07-07-2003, 02:24	#9 (permalink)
jaleo Insane Poster Join Date: May 2003 Location: Spain Posts: 65 Member: 29370 Status: Offline Thanks: 4 Thanked 2 Times in 2 Posts	...finally Passo works!!! (me again) (even if you lock your phone and "Contact Service Provider" message appears in the screen) After flashing with the correct unlock flash, remove the original provider SIM and enter the SIM of the other provider you want to unlock... enter the PIM and connect the phone... start Motoflasher and later Passo and clic "SEARCH"... the program start a brute force attack to find the correct code and finally gives it (the time for this process will vary). But if the code doesn`t work, try again (even if you finally lock the phone and "Contact Service Provider" appears)... simply wait 50 minutes and this message dessapears... then repeat the whole process again. In my first test the code that gave Passo was wrong and with later test (3 intents) I only obtained the damned message "Contact Service Provider" but finally the last code works. I use the P2K driver that PST install but you can use this: http://lggroup.cjb.net/down/p2k_driver_1.33.zip I know is hard to install and setup these programs but they works... believe me... Thanks SPunlock Last edited by jaleo; 07-07-2003 at 02:38.

07-07-2003, 17:57	#11 (permalink)
jaleo Insane Poster Join Date: May 2003 Location: Spain Posts: 65 Member: 29370 Status: Offline Thanks: 4 Thanked 2 Times in 2 Posts	For c33x I use this unlock edition firmware: http://lggroup.ajolote.net/down/TA02...unlock.vfl.rar Password: lggroup.cjb.net Anybody knows the unlock edition firmware for c35x? Thanks Last edited by jaleo; 07-08-2003 at 08:09.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-05-2003, 03:39	#3 (permalink)
aliwali No Life Poster Join Date: Nov 2001 Age: 44 Posts: 1,105 Member: 7363 Status: Offline Thanks: 0 Thanked 24 Times in 11 Posts	pass to my office near u about 02 mns by taxi and u can unlock with clip

07-05-2003, 03:45	#4 (permalink)
jaleo Insane Poster Join Date: May 2003 Location: Spain Posts: 65 Member: 29370 Status: Offline Thanks: 4 Thanked 2 Times in 2 Posts	I tried again with Passo and give me different code!!! It's normal? Of course the new code doesn't work with my provider... so i decide to finish the test because I don't want to lock the phone Thanks to SPunlock for cracking this software... but it's terribly buggy and doesn't works for me (I hope others can).

07-05-2003, 09:38	#5 (permalink)
douda Freak Poster Join Date: Jan 2002 Location: Tunisia Posts: 212 Member: 8903 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	for me the same code is generated 20 times !!

07-05-2003, 18:43	#6 (permalink)
TriggaHappy Insane Poster Join Date: Jun 2003 Posts: 68 Member: 30846 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	I'm having problems installing the P2k Drivers under WIN98... On XP they work fine, but in 98 I end up having 2 or sumtimes 3 Motorola USB Modems. Any ideas?

07-05-2003, 19:34	#7 (permalink)
Logslander Junior Member Join Date: Jul 2003 Location: FRANCE Posts: 35 Member: 33460 Status: Offline Thanks: 0 Thanked 1 Time in 1 Post	do you test with clip?

07-05-2003, 23:13	#8 (permalink)
Brka No Life Poster Join Date: Jun 1999 Location: Serbia Age: 37 Posts: 2,163 Member: 163 Status: Offline Thanks: 523 Thanked 821 Times in 317 Posts	yeah ... and did you flashed phone with unlock flash before reading codes ????? b.r. ALex.

07-07-2003, 10:25	#10 (permalink)
douda Freak Poster Join Date: Jan 2002 Location: Tunisia Posts: 212 Member: 8903 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	what unlock flash did you used?? and please post link for download thanks

07-08-2003, 09:02	#12 (permalink)
the_frightener No Life Poster Join Date: Jan 2003 Posts: 2,248 Member: 20069 Status: Offline Thanks: 0 Thanked 129 Times in 47 Posts	jaleo hola amigo my uncle send me C350 from uk ... i'm having the same problem "enter subsidy code" ...i've also have a mini usb data cable of c330 ...but i don't have any soft like Motorola PST 6.0 MSS 3.2.3 Cracked Flash.exe only (Motorola Flasher Software 9.9.9 cracked by SPunlock) Passo.exe only (cracked by SPunlock) so plz tell me the link for the soft n plz also guide me to solve this problem ... ... i'll be so obliged, if u amigo could do so... Gracias

07-09-2003, 00:44	#13 (permalink)
jaleo Insane Poster Join Date: May 2003 Location: Spain Posts: 65 Member: 29370 Status: Offline Thanks: 4 Thanked 2 Times in 2 Posts	To unlock the c350 with Passo searcher you need the unlock edition firmware for c350... nowadays only exits for c33x & t720 ... I hope somebody release this type of firmware for c350. To download all stuff (Passo and Motoflasher) simply connect to http://www.spunlock.com Best Regards.

10-30-2003, 22:43	#14 (permalink)
GSMVN Freak Poster Join Date: Aug 2003 Location: www.gsm.com.vn Posts: 396 Member: 36903 Status: Offline Sonork: 64982 Thanks: 1 Thanked 2 Times in 2 Posts	Anybody has the Unlock FW for C350 ?? Pls share ... Thanks !

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Has anyone got codes from the Blackberry Unlock guy that was doing the free unlock...	2low4snow	BlackBerry (RIM)	4	01-27-2009 20:28
my 101x succsessfully got code from server but.....	fadhel	SAGEM JTAG UNLOCKER	6	02-26-2008 15:28
Got code from SagemCDR 10.1 for x5m , code accepted, but still "SimLock"	nonu_don	ARM9 BASED M62 / M62+	21	01-29-2004 18:25
How to change language after unlock C330 with PAsso???	sifasli	P2k Series	5	10-23-2003 14:44
Strange C330... Got the codes but wont unlock...	Burnt Cobba	Phone Unlocking Codes & Maps	3	06-22-2003 21:37

11-02-2003, 22:49	#15 (permalink)
bakarioss No Life Poster Join Date: Oct 2003 Location: @@Afsus_ tunisia-sat@@ Age: 52 Posts: 1,642 Member: 42750 Status: Offline Thanks: 194 Thanked 114 Times in 100 Posts	www.gsfactory.com