AL21 CF110 bad cut solution needed

[Svetli]

i have one AL21 with no signal after bad cut.
any solution ?

[sidcell]

I am need!!!!!!!!!!!!!!!!!!!!!!!!!!!! AL21 no service

[Svetli]

i repair my AL21. for that you need microscope.

[Chris02]

Probably it is problem of a cold solder connection. Rehot area around TP with some flux and try again!

-=moved to HW section=-

[Gerti]

I think you need to use Martech....

[Svetli]

as i write on this topic: AL21 CF110 bad cut solution needed

i think that sidcell have same problem like me. if problem is other then sidcell will not post in this topic.

then, for unlock AL21 u can yuse Joker but if after that have problem with signal. 99% problem is from bad cut on TP.

i use microscope and scalpel to repair phone. on second layer under TP are other 2 wires. if you cut it then will have problem with signal !

no need to rehot phone with flux or Martech. just get one microscope and scalpel.
that's all.

[izvrateniaka]

Originally Posted by Svetli

as i write on this topic: AL21 CF110 bad cut solution needed

i think that sidcell have same problem like me. if problem is other then sidcell will not post in this topic.

then, for unlock AL21 u can yuse Joker but if after that have problem with signal. 99% problem is from bad cut on TP.

i use microscope and scalpel to repair phone. on second layer under TP are other 2 wires. if you cut it then will have problem with signal !

no need to rehot phone with flux or Martech. just get one microscope and scalpel.
that's all.

Svetli can you please post some pictures or diagrams where this 2 wires is conected. I have a31 bad cut and bord is similar like cf110. I see 2 wires but i can see where they go and how they conected. The phone don't power up but flash and unlock just fine. 10x in advance

[Svetli]

i repair my phones. but you will need obligatory microscope to repair your phone.
if you have microscope then you will not need my pictures.
but if you need it i will share to all.

regards Svetli

[izvrateniaka]

Originally Posted by Svetli

i repair my phones. but you will need obligatory microscope to repair your phone.
if you have microscope then you will not need my pictures.
but if you need it i will share to all.

regards Svetli

10x but its not expensive phone. Effort for repair is cost much than gsm
You know that this phone cost 80 leva(40euro) new in GLOBUL . Now i have spare parts for this phone. But if easier solution is come out i will glad.

[sin_daemon]

Originally Posted by Svetli

i repair my phones. but you will need obligatory microscope to repair your phone.
if you have microscope then you will not need my pictures.
but if you need it i will share to all.

regards Svetli

First time when i cut that king of phone i cut the underlayer Wire too, but after a hard work i repair it, with the scalpel, it makes me very mad. Man got to be carefull. Siemens has very soft PCBs.

Брат напрово ми са иба майката докато я възстановя тая тъпа пътечка, вече внимавам!

[Svetli]

yes, Siemens has very soft PCBs.
get the microscope and ALL will be fine with this phones !


good luck to all.