Your Motherboard Is Supporting Or Not? - GSM-Forum

needi · 12-04-2003, 01:25

Well after a long experience with the motherboards and the third party softwares i have came to a conclusion that i want to share with you guys.

The best and supporting motherboards are following.

1. SIS 735-746 chipsets and almost all
2. N-vidia Nforce chipsets

And the half working are Intel chipsets.The VIA chipsets are worst of all.You can have really silly error messeges while using VIA chipsets motherboards.And with the above said there is no problem, you can run any kind of software without any problems.The cheapest of all SIS 735 chipset motherboard from ECS is around 40$.I hope this information will be usefull for the members.Any questions regarding the computer hardware are welcome.

WBR.

Mastah-GSi · 12-04-2003, 09:41

To use the Matrix I use a Toshiba Satellite Pro 4200.
It's a Pentium III 500Mhz with 64mb memory. Don't know what kind a chipset there is in it, but it's working really fine.

Now I'm trying a AMD K6 (equals PII) 333mhz with 512mb memory with Ali chipset.
Just flashed a 3310 DCT3 with third party software (Rolis 4.77) and it works just fine.
I'll try a DCT4 later on.
Last night I alterd the revision 22.8.03 to work with 5210. Hopefully it works...

mr_x4you · 12-04-2003, 11:16

Well, a good programer makes his sw run on ant MB, no matter chipset !

needi · 12-04-2003, 20:02

yes if the soft developer is a good programmer.

Digitec · 12-06-2003, 01:39

some chipsets does not like shortcut on COM port between PIN 1 and PIN 2 of RS 232 interface. This shortcut is req. by some Nokia SW.

12-06-2003, 02:15

For me, wont work on IBM Laptops.
Al other desktops i have, it works, only can't flash DCT4 phones with P II@350, it's too slow.

a4tech · 12-06-2003, 03:15

is there any comment on using AMD Processors?

i am using Duron and Athlon for DCT3 and DCT4...no problems encountered....

fgl30 · 12-06-2003, 11:38

Well, I use 2 AMD K6 II, Matrix works very good...... and use 1 (old) Celeron (****/slow) but Matrix works good too...... and I dont conect cables in ports...I use long cable extension...but Matrix works good any way......

needi · 12-06-2003, 20:19

No there is no problem with the CPU's it self.Only matters is the motherboard architechure and its chipsets.For AMD the best chipsets are SIS and N-vidia.And if you are using them absolutely no problem.Yes the CPU speed really mattersand for some software you need more memory too.And also in some cases i experienced that the SDRAM is better than DDRAM.

BEST REGARDS.

12-04-2003, 01:25	#1 (permalink)
needi No Life Poster Join Date: Dec 2002 Location: Near phones Age: 46 Posts: 1,154 Member: 18303 Status: Offline Thanks Meter: 3	Your Motherboard Is Supporting Or Not? Well after a long experience with the motherboards and the third party softwares i have came to a conclusion that i want to share with you guys. The best and supporting motherboards are following. 1. SIS 735-746 chipsets and almost all 2. N-vidia Nforce chipsets And the half working are Intel chipsets.The VIA chipsets are worst of all.You can have really silly error messeges while using VIA chipsets motherboards.And with the above said there is no problem, you can run any kind of software without any problems.The cheapest of all SIS 735 chipset motherboard from ECS is around 40$.I hope this information will be usefull for the members.Any questions regarding the computer hardware are welcome. WBR.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Check your mobile is original or not (for new guys)	meo786pk	Nokia Hardware & Hardware Repair	4	10-25-2007 07:19
C139 is supported or not?.	harim_1981	Multi-Box	4	10-21-2007 16:25
This is Supported or not	guedes666	BB5BOX	1	09-19-2007 13:37
so, the u8290 is supported or not?	.:bono:.	Redbox	1	06-08-2006 16:41

12-04-2003, 09:41	#2 (permalink)
Mastah-GSi Freak Poster Join Date: Jul 2003 Location: Enschede, Netherlands Age: 41 Posts: 415 Member: 34652 Status: Offline Thanks Meter: 5	To use the Matrix I use a Toshiba Satellite Pro 4200. It's a Pentium III 500Mhz with 64mb memory. Don't know what kind a chipset there is in it, but it's working really fine. Now I'm trying a AMD K6 (equals PII) 333mhz with 512mb memory with Ali chipset. Just flashed a 3310 DCT3 with third party software (Rolis 4.77) and it works just fine. I'll try a DCT4 later on. Last night I alterd the revision 22.8.03 to work with 5210. Hopefully it works...

12-04-2003, 11:16	#3 (permalink)
mr_x4you Registered User Join Date: Jun 2001 Location: x Posts: 3,295 Member: 4989 Status: Offline Thanks Meter: 13	Well, a good programer makes his sw run on ant MB, no matter chipset !

12-04-2003, 20:02	#4 (permalink)
needi No Life Poster Join Date: Dec 2002 Location: Near phones Age: 46 Posts: 1,154 Member: 18303 Status: Offline Thanks Meter: 3	yes if the soft developer is a good programmer.

12-06-2003, 01:39	#5 (permalink)
Digitec Freak Poster Join Date: Oct 2003 Age: 55 Posts: 195 Member: 40921 Status: Offline Thanks Meter: 0	some chipsets does not like shortcut on COM port between PIN 1 and PIN 2 of RS 232 interface. This shortcut is req. by some Nokia SW.

12-06-2003, 02:15	#6 (permalink)
legija Guest Posts: n/a Member:	For me, wont work on IBM Laptops. Al other desktops i have, it works, only can't flash DCT4 phones with P II@350, it's too slow.

12-06-2003, 03:15	#7 (permalink)
a4tech Freak Poster Join Date: Apr 2003 Location: Mira Verde Posts: 268 Member: 26377 Status: Offline Thanks Meter: 0	is there any comment on using AMD Processors? i am using Duron and Athlon for DCT3 and DCT4...no problems encountered....

12-06-2003, 11:38	#8 (permalink)
fgl30 No Life Poster Join Date: May 2003 Posts: 1,357 Member: 27881 Status: Offline Thanks Meter: 11	Well, I use 2 AMD K6 II, Matrix works very good...... and use 1 (old) Celeron (****/slow) but Matrix works good too...... and I dont conect cables in ports...I use long cable extension...but Matrix works good any way......

12-06-2003, 20:19	#9 (permalink)
needi No Life Poster Join Date: Dec 2002 Location: Near phones Age: 46 Posts: 1,154 Member: 18303 Status: Offline Thanks Meter: 3	No there is no problem with the CPU's it self.Only matters is the motherboard architechure and its chipsets.For AMD the best chipsets are SIS and N-vidia.And if you are using them absolutely no problem.Yes the CPU speed really mattersand for some software you need more memory too.And also in some cases i experienced that the SDRAM is better than DDRAM. BEST REGARDS.