e810 signal problems - GSM-Forum

thephoneman · 02-21-2006, 17:19

hello all,
i have an e810, it will connect2a network when manually selected then hold full signal but keeps on call failed. it was liquid damaged- its not the imei. its been cleaned, flashed, full eeprom and custom reset and been fully reseted using service software. Ive took the back off and stripped as in other thread, if remove ant. no network service-so poss not that.
as u can see iv really don a lot on this one, any ideas???

thanks in advanced.

cellularry · 02-21-2006, 21:52

Have you tried to change PA and filter. it might help.
But in case of water or liquid damage all solutions are trial nothing is confirmed.
Keep on changing ICs until phone is done.

NEGRIA · 02-21-2006, 22:14

u change case? if is not original phone make this problem the shield must be very good at this phone i find this problem at more samsung and al have same problem shield protection try this way 90% this is the problem!

02-21-2006, 17:19	#1 (permalink)
thephoneman No Life Poster Join Date: Jun 2003 Location: ENGLAND Age: 53 Posts: 800 Member: 30709 Status: Offline Thanks Meter: 45	e810 signal problems hello all, i have an e810, it will connect2a network when manually selected then hold full signal but keeps on call failed. it was liquid damaged- its not the imei. its been cleaned, flashed, full eeprom and custom reset and been fully reseted using service software. Ive took the back off and stripped as in other thread, if remove ant. no network service-so poss not that. as u can see iv really don a lot on this one, any ideas??? thanks in advanced.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SGH-E810 keypad problem	dr_aybyd	Samsung Hardware Repair	3	03-06-2009 10:32
E810 flash problem - NS Pro	fonestyle	NSPRO	0	01-17-2007 21:29
E810 Earpich Problem	Jr Telecom	Samsung Hardware Repair	0	12-24-2006 14:49
E810 big problem	wayne_icu	Samsung Hardware Repair	1	03-09-2006 11:38
E810 flashing problem...	The SAINT®	UFS2 + UFS3-Tornadoflasher	2	07-02-2005 07:28

02-21-2006, 21:52	#2 (permalink)
cellularry No Life Poster Join Date: Oct 2003 Location: Lebanon / Nigeria Age: 52 Posts: 1,085 Member: 42276 Status: Offline Thanks Meter: 47	Have you tried to change PA and filter. it might help. But in case of water or liquid damage all solutions are trial nothing is confirmed. Keep on changing ICs until phone is done.

02-21-2006, 22:14	#3 (permalink)
NEGRIA Freak Poster Join Date: Jul 2003 Posts: 232 Member: 33954 Status: Offline Thanks Meter: 10	u change case? if is not original phone make this problem the shield must be very good at this phone i find this problem at more samsung and al have same problem shield protection try this way 90% this is the problem!