Very Sticky - GSM-Forum

championi · 11-14-2006, 14:05

Hi...I had my wifes E350 repaired a week or so ago (needed new cable)....it is now working ok...but doesnt slide open and closed very well...not as good as my 500......I have tried putting a little bit of WD40 on it but it doesn't seem to help...is there any way I can slacken it a bit...thanks

fonegeeks · 11-20-2006, 13:52

We don't have e350 here yet , but if it is a slide phone, and will not slide up and down properly ,then you have got the retainer screws mixed up.They look very similar , but are about half a mm different. The smaller ones go onto the slide retainer. If you strip the phone down and seperate the different screws, you will see the difference. Have done this myself, so know what you have done...

11-14-2006, 14:05	#1 (permalink)
championi Junior Member Join Date: Nov 2006 Posts: 1 Member: 391013 Status: Offline Thanks Meter: 0	Very Sticky Hi...I had my wifes E350 repaired a week or so ago (needed new cable)....it is now working ok...but doesnt slide open and closed very well...not as good as my 500......I have tried putting a little bit of WD40 on it but it doesn't seem to help...is there any way I can slacken it a bit...thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tornado very very very very very big problem	osama abbass	UFS2 + UFS3-Tornadoflasher	1	04-28-2009 01:45
Why I read KI's speed is very very very slow with sim_scan 2.0 ?	pxcom	Sim Cloning and Scaning	0	04-13-2003 16:38
Very Very Very Strange 3310 Problem	mp3hot	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	03-24-2002 12:15

11-20-2006, 13:52	#2 (permalink)
fonegeeks Freak Poster Join Date: Oct 2005 Location: perth aust. Posts: 125 Member: 188959 Status: Offline Thanks Meter: 7	We don't have e350 here yet , but if it is a slide phone, and will not slide up and down properly ,then you have got the retainer screws mixed up.They look very similar , but are about half a mm different. The smaller ones go onto the slide retainer. If you strip the phone down and seperate the different screws, you will see the difference. Have done this myself, so know what you have done...