T10 Wont Charge! - GSM-Forum

DABOSS · 06-16-2001, 19:35

Please can someone help......My T10 will not charge

Any Surgesstions appreciated !!!

[email protected]

looker · 06-16-2001, 19:45

Hi DABOSS,
Try to check the system conector of your T10.
I had one after fall in the watter and sys. con. and base board looks so bad.
But U should to write what was happen with your T10
best regards
looker

ssemmedo · 06-17-2001, 07:11

u must exite the battery with 12v first and them after charge the phone.
Good lock!

CellM@n · 06-19-2001, 10:12

If it is hardware problem, check Connection between (+) parts of System Connector(for charging ), to Microcircuit beside Battery Connector (5 Pin). It should be SHORT ( 0 Ohm). If not, you need to jumper here.

Second possible things : Check Connection between (+) part of Sys. Connector, to board behind it. In should be o OHM.

Hope this Help

Regards

06-16-2001, 19:35	#1 (permalink)
DABOSS Freak Poster Join Date: Jun 2001 Location: London Age: 41 Posts: 489 Member: 4926 Status: Offline Thanks Meter: 5	T10 Wont Charge! Please can someone help......My T10 will not charge Any Surgesstions appreciated !!! [email protected]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
t10 sef charging	uncle smallz	Old Ericsson Phones & Sony Phones	0	12-20-2006 09:01
3310 Wont charge!	connorsdad	Nokia Hardware & Hardware Repair	7	06-08-2004 22:04
t10 shows charging without charger	doctorvatson	Sony Ericsson Hardware Repair	2	07-12-2002 13:34
T10 NOT CHARGE	mujie	Sony Ericsson Hardware Repair	1	01-26-2002 00:41
T10 no charging after battery empty	iHi	Sony Ericsson Hardware Repair	8	11-02-2001 16:54

06-16-2001, 19:45	#2 (permalink)
looker Insane Poster Join Date: May 2001 Location: Europe Posts: 72 Member: 4747 Status: Offline Thanks Meter: 0	Hi DABOSS, Try to check the system conector of your T10. I had one after fall in the watter and sys. con. and base board looks so bad. But U should to write what was happen with your T10 best regards looker

06-17-2001, 07:11	#3 (permalink)
ssemmedo Freak Poster Join Date: May 2001 Location: Cape Verde Age: 49 Posts: 232 Member: 4596 Status: Offline Sonork: ssemmedo Thanks Meter: 3	u must exite the battery with 12v first and them after charge the phone. Good lock!

06-19-2001, 10:12	#4 (permalink)
CellM@n No Life Poster Join Date: Feb 2001 Location: Planet EARTH Age: 50 Posts: 1,209 Member: 3194 Status: Offline Thanks Meter: 41	If it is hardware problem, check Connection between (+) parts of System Connector(for charging ), to Microcircuit beside Battery Connector (5 Pin). It should be SHORT ( 0 Ohm). If not, you need to jumper here. Second possible things : Check Connection between (+) part of Sys. Connector, to board behind it. In should be o OHM. Hope this Help Regards